Cub Cadet Commercial 590-852-150 Manual do operador - Página 8
Procurar online ou descarregar pdf Manual do operador para Equipamento para relva e jardim Cub Cadet Commercial 590-852-150. Cub Cadet Commercial 590-852-150 16 páginas. Triple rear bagger kit for fan assisted kit
Imprimir páginaSECTION 3: ASSEMBLY & OPERATION
Before Assembly
NOTE: References to left, right, front and rear of the
mower are from the operator's position. See page 2 for
chute deflector requirement.
•
Place the mower on a firm and level surface, disengage
PTO, stop mower engine and set the parking brake.
•
Identify all loose parts according to Figure 1 on page 7.
Identify all the items of the hardware pack according to
Figure 2 on page 7.
Tools Required
1.
Socket and adjustable wrenches or wrenches of the
following sizes: 1/2, 3/4, 9/16 and 15/16 inch.
2.
Torque wrench
Attaching Weight Bars
•
Remove the two bolts that hold two weight bars on the
rear bumper cross bar of the mower. Remove the two
weight bars. See Figure 3.
Bumper Cross Bar
Figure 3
•
Place weight bar bracket on the front frame of the mower.
See Figure 3 .
•
Secure with an U Bolt and two center lock flange nuts
from Group A of the hardware pack on each side of the
front axle of the mower. See Figure 4.
Front Axle
Figure 4
•
Place the three weight bars as shown in Figure 5. Two of
these weight bars were removed from the rear of the
mower while the third was included in the bagger kit.
Weight Bars
Center Lock
Flange Nut
Weight Bar
Bracket
U Bolt
•
Secure all weight bars to the weight bar bracket and the
mower frame with hex bolt (6.25") and top lock flange nut
from Group A of the hardware pack. See Figure 5.
Repeat on the other side.
Flange
Nut
Weight
Bar (Old)
Weight
Bar Bracket
Assembling the Catcher Support Bracket
Assemble the Upright Gussets to the Upright Mounting
Brackets using the hex bolts and flange nuts from Group D.
Next, attach the assembled Gussets to the Catcher Support
Bracket using the Lock Pins. See Figure 6.
Hardware Pack
Group D
Upright Mounting
Bracket
Attaching Catcher Support Bracket
With the two upright mounting brackets and the two upright
gussets attached to the two ends of the catcher support
bracket, as in the previous step:
•
Remove the two hex bolts on each side of the rear
bumper plate, located in positions A and B in Figure 7.
Save the hardware.
•
Place the catcher support bracket assembly on the rear
frame of the mower aligning the hole on each upright
mounting bracket to corresponding hole at A or B. See
Figure 7.
8
Weight
Bar (New)
Weight
Bar (Old)
Figure 5
Catcher Support Bracket
Lock Pin
Upright Gusset
Figure 6
Hex
Bolt