3D Hobby Shop SLICK 540 Manual de montagem - Página 11

Procurar online ou descarregar pdf Manual de montagem para Brinquedo 3D Hobby Shop SLICK 540. 3D Hobby Shop SLICK 540 19 páginas.

Install motor with the longer 3mm screws as shown. Please note that the motor is installed IN FRONT of

the firewall.

NOTE: Your kit contains 4 plastic motor mount spacers. They may be used as shown to space the motor

away from the firewall as needed for cowl clearance.

Install speed control to fuselage with short velcro strip or zip ties.

The cowl is mounted onto the fuselage with 4 wood screws. These screws go into the small plywood

squares on the front inside of the fuselage. The following procedure is helpful to be sure the wood

screws hit the plywood squares:

Install the canopy hatch (if the canopy hatch is not installed when you fit the cowl, it may be

impossible to fit the canopy hatch after the cowl is installed!).

Tape small strips of paper over the plywood cowl-mounting tabs as shown below. Install the cowl and

align. Use the small pieces of paper as guides to make holes in the cowl and install the wood screws.

Remove the cowl and screws and soak the plywood mounting tabs in thin CA glue. This will strengthen

the mounting tabs.