Dish Network Duo ViP 222 Configuração do controlo remoto - Página 2
Procurar online ou descarregar pdf Configuração do controlo remoto para Controlo remoto Dish Network Duo ViP 222. Dish Network Duo ViP 222 17 páginas. Dish network remote control setup guide
Também para Dish Network Duo ViP 222: Começar a trabalhar (2 páginas), Começar a trabalhar (2 páginas)
Imprimir página
222.book Page 58 Tuesday, July 25, 2006 1:30 PM
Chapter 9
Improving Receiver Control
I
MPROVING
These instructions help you improve your remote control settings to best operate your
satellite receiver. Use the following instructions to make your remote control operate more
efficiently with your receiver.
Changing the Address for Remote Control 2
Because UHF signals travel long distances and go through walls, a neighbor's remote
may control your receiver by mistake. To keep this from happening, you can change the
remote address. You can also use these instructions to change the address on Remote
Control 1.
1
Press SYSTEM INFO on the receiver's front panel. The System Information screen
displays on the nearby TV and shows the Remote Address.
Write down the Secondary Remote Address:
If changing the address for Remote Control 1, write down
the Primary Remote Address:
2
Press and hold SAT on your remote control for about three seconds, until all of the mode
buttons light up, and then let go of SAT.
3
Use the NUMBER PAD to enter any number between 1 and 16, but not the one you wrote
in step 1.
4
Press POUND (#). If you entered the address correctly, SAT will flash three times.
Write down the number you entered:
5
Press RECORD. Make sure the Remote Address you see on the System Information
screen is the same as the one you entered in step 3. If it isn't, the remote cannot control
the receiver.
6
Press SELECT to close the System Information screen.
58
R
C
ECEIVER
ONTROL