3D Robotics 3DR RADIO V2 Manual de início rápido - Página 3

Procurar online ou descarregar pdf Manual de início rápido para Rádio 3D Robotics 3DR RADIO V2. 3D Robotics 3DR RADIO V2 4 páginas.

CONNECT TO TABLET

Connect the ground module to your tablet using the Android adapter cable. Connect the colored end

to the tablet and the black end to the radio. In

SETTINGS

To change the radio settings in the mission planner, connect the radio to your computer, but do not

select Connect. Radios can only be configured while unconnected to MAVLink. Select

3DR

Radio, and

Load Settings

All settings should be the same for both modules. Ensure that the

radio to enable pairing. Select

Net IDs do not conflict.

Use the configuration options on this screen to apply the correct airspace regulation requirements

for your area. You are responsible for complying with all airspace regulations in your area, including

frequency restrictions, power levels, and licenses. For more information on configuring 3DR Radios to

comply with local regulations, visit the online documentation at goo.gl/Tsrksf.

DroidPlanner

to configure the radios.

Save Settings

to apply settings. For flying with friends, make sure your

View the strength of the radio signal in the

mission planner's flight data screen.

TIPS

Orient the ground radio

antenna vertically for

maximum range.

or Andropilot, select Connect.

DroidPlanner Flight Data screen

Net ID

setting is identical on each

Initial

Setup,