disperator 8075 Manual de instalação, utilização e cuidados - Página 3
Procurar online ou descarregar pdf Manual de instalação, utilização e cuidados para Compactador de lixo disperator 8075. disperator 8075 13 páginas. Waste compactor
Imprimir página1. Installation
1.1 Unpackning the Compactor
To protect the compactor mechanism the unit is
shipped from the factory with packing material in
the waste container and the compacting plate in
the down position.
Return the compacting plate to the up position by:
a) attaching the provided cord set to the back of
the unit,
b) plugging the cord into an electrical outlet,
c) turning the key lock switch to the
"ON"-position, and
d) closing the door.
Once the door is closed the unit will run and the
compacting plate will travel to the up-position.
Open the door and slide out the waste container
in order to remove the packing material in the
container.
1.2 Free-standing
As shipped the compactor is only configured
for built-in installation. This compactor can be
converted from built-in to free-standing with the
use of a "Toe kick support" (sold separately) or
fixing plates for compactor feet (sold separately).
Caution: Failure to use the "Toe kick support" in a
free-standing installation may cause the compactor
to be unstable during operation.
1.3 Built-in Installation
TOP OF
COMPACTOR
FRONT OF
COMPACTOR
Two under counter mounting straps are provided
with the delivery of the compactor. Use these
straps to secure the compactor to the underside
of a counter top. Fasten the slotted end of the
straps to the compactor using the holes in the top
of the compactor cabinet with screws provided as
shown in the picture above.
Under counter opening
The compactor requires a minimum under counter
opening of:
• 381mm wide
• 876mm high
• 610mm deep
Plan to provide an electrical outlet in the opening
that meets all applicable electrical codes and
requirements. See heading "Grounding instructions"
on page 2 above for specific information.
Electrical outlet shall be minimum 305mm above
floor level.
Cord clamp
The compactor is equipped with a 1.8m long
power cord. Use the cord clamp to prevent
excess power cord from being pinched beneath
the counter during installation or service (see
picture below).
1.4 Levelling the Compactor
The compactor has four adjustable levellers – two
rollers in the rear and two legs in the front. They
allow to adjust for uneven floor and also to trim
the unit up to fit an under counter installation.
To level the back of the compactor
Tip the back of the compactor up and onto a
wood block. Loosen the adjusting screws only far
enough to move the rollers to a higher or lower
slot. Retighten the adjusting screws and remove
the wood block.
CORD
CLAMP