Displays2go SMHG Series Manual do utilizador - Página 5
Procurar online ou descarregar pdf Manual do utilizador para Mobiliário de interior Displays2go SMHG Series. Displays2go SMHG Series 6 páginas. Tension-suspended glass hanging shelves
Imprimir página
Attaching Glass Shelving
Multiple configurations available. Parts may vary.
1) Loosen the screw in the shelving hardware and remove it. Set aside, being careful not to lose it. NOTE: Part is small and may be lost.
2) Loosen the screw that the glass will slide into; screw does NOT need to be fully removed.
3) Slide the wire into the groove on the hardware. Then, replace and tighten the screw to hold it in place.
NOTE: You may need to further adjust this, so do not fully tighten until all hardware is in place and glass shelving is attached.
4) Repeat steps 1-3 for each piece of hardware required.
5. Carefully lift glass into place and slide edges into the hardware. Two people are suggested for this process.
B
C
6) Tighten down the screw to hold in place. DO NOT over-tighten; may result in breakage in glass.
7) Repeat steps 5-6 for each side of the glass.
8) Using a level, adjust tightness of screws and locations of hardware until desired location is achieved and shelves are level.
9) Repeat steps 1-8 for each shelf.
C
B
B
5