Displays2go SMHGSET4 Manual do utilizador - Página 4
Procurar online ou descarregar pdf Manual do utilizador para Mobiliário de interior Displays2go SMHGSET4. Displays2go SMHGSET4 6 páginas. Tension-suspended glass hanging shelves
Imprimir página
1) Drill holes into ceiling, using the map on page 3 as a guide. Be sure to measure carefully, to ensure that the shelves hang properly.
2) Once the holes are drilled, insert and secure anchors into each hole.
3) Unscrew part D, remove the cone top and insert screw
through the cone, as shown. Then, fasten the cone to the
ceiling, using the screw. Repeat for each attachment point.
4) Loosen the part D (at right) with the Allen key, and feed
the rope through the hardware. Then, use the
steps below to crimp the rope into place.
5) Feed the steel wire through the second hole
in the collar, according to the arrow in Figure 1.
The wire head should be level with the collar,
not protruding.
Then, pull the wire rope back, as shown by the arrow in Figure 2 to ensure the wire loop is small.
After the loop is minimized, use the pliers to crimp the aluminum parts, in order to secure the wire loop,
as shown in Figure 3. Then, re-tighten the allen keys back down onto the wire.
6) Slide the round copper piece (D) up to the
collar, then use the Allen key to tighten the two
screws on this piece to prevent slippage.
7) Insert the wire rope into the cone part, as
shown at right, then rotate and tighten the tube.
8) Repeat all steps for each of the
4
hanging points on the ceiling.