Displaysense DTS650 Folha de instruções - Página 2

Procurar online ou descarregar pdf Folha de instruções para Mobiliário de interior Displaysense DTS650. Displaysense DTS650 3 páginas. Silver corner glass display cabinet - 650mm

Imprimir página

1. Insert all shelf supports (A) into each upright using the markers for guidance by twisting in to

position, then attach the adjustable feet (B) into the bottom of each upright

2. Place the back panel (C) onto a flat, soft surface and slide the two large cross bars (D) into the top

and bottom corners of the panel, securing in place with the Allen key, then slide the glass back

panel (E) in between the two cross bars (D)

3. Finish the back by sliding the single upright (F) onto the glass panel and cross bars (D) and secure

with the Allen key

4. Next, attach the cross bars labelled G to the top and bottom of the back panel on the left side and

slide the glass side panel (I) into place

5. Repeat the same for the cross bars labelled H, sliding onto the

right hand back panel then slide the second glass panel into place

6. Attach the assembled front panel (J) by sliding into place

Hint: If you struggle to get the cross bars to freely slide into the

front panel gradually loosen the grub screws on the cross bars and re-tighten once the panel is

fitted

Please note: We advise that there are three people there to assist, with two people holding each

side panel in place for stability while the third person positions the front panel and attaches to the

cross bars

7. Once all components are screwed tightly in place,

gently lift the cabinet onto its feet

8. Attach the hinges (L) to the glass door (K) by screwing

into place onto the top and bottom of the glass,

ensuring that each hinge is 8 - 10mm in from the inside edge of the glass

9. Insert the hinge plugs (M) into the top and bottom holes on the front bars

10. Lift the glass door into the cabinet, aligning top and bottom hinges with the

corresponding hinge plugs