Distech Controls Allure ECB-103 Manual de instalação - Página 2
Procurar online ou descarregar pdf Manual de instalação para Controlador Distech Controls Allure ECB-103. Distech Controls Allure ECB-103 16 páginas.
Também para Distech Controls Allure ECB-103: Manual de instalação (16 páginas)
Imprimir página
Mounting Instructions
The Allure Allure EC-Smart-Vue has been specially designed for easy installation. However, certain conditions apply when choosing a suitable location
for the device:
£
Install the device in a location of average temperature approximately 5 ft (1.5 m) above the floor
£
The device should not be installed on an exterior wall.
£
The device should not be installed near a heat source.
£
The device should not be installed near an air discharge grill.
£
The device should not be installed in a place where it can be affected by the sun.
£
Install the device in an area that provides proper device ventilation. Nothing must restrain air circulation to the device.
The Allure Allure EC-Smart-Vue has not been designed for outdoor use.
Mounting hardware with a separate sub-base is provided with the device for installation on dry wall or on an electrical junction box.
Wall Mounting Installation Procedure
The Allure EC-Smart-Vue can be mounted on a dry wall using supplied screws.
1. Remove the security screw from the device (See Device Mounting [pg. 3]).
2. Open the device by pressing in the two (2) tabs on the bottom of the device and pulling the bottom side of the front plate out.
3. Set any jumpers (see Connector and Jumper Location, Identification and Configuration [pg. 3]).
4. Pull all cables 6" (15cm) out of the wall, and insert them through the central hole of the back plate.
5. Align the back plate with the wall and mark the location of the mounting holes on the wall. Make sure to orient the proper side of the back plate facing
upwards.
6. Remove the back plate and drill holes in the wall if necessary.
7. Install anchors in the wall if necessary.
8. Make sure that the mounting surface is flat and clean.
9. Screw the back plate onto the wall. Do not over tighten.
10. Plug the wire(s) into the connector(s).Gently push excess wiring back into the wall.
11. Reattach the front plate and make sure it clips tightly into place.
12. Install security screw.
Device Dimensions
1.15
(28.84)
Model with
motion
sensor
Figure 2:
Front view, bottom view, back plate, and side view for models with and without motion sensor.
2 / 16
3.29
(83.57)
4.62
(117.27)
Bottom View
1.06
(26.81)
Model without
motion
sensor
2.36
(60.00)
Mounting Base Plate Shown Detached
2.37
(60.30)
3.31
0.12
(84.00)
(3.00)
0.20
(4.98)
Unit Legend: inches (mm)