CAME Z Series Manual - Página 2

Procurar online ou descarregar pdf Manual para Painel de controlo CAME Z Series. CAME Z Series 4 páginas. Control board
Também para CAME Z Series: Manual (8 páginas), Manual (20 páginas), Manual (4 páginas), Manual (17 páginas), Manual (17 páginas), Manual (13 páginas), Manual (13 páginas), Manual (16 páginas), Manual (16 páginas), Manual (12 páginas), Manual (12 páginas), Manual (18 páginas), Manual de instalação (11 páginas), Manual (8 páginas), Manual (20 páginas), Manual (12 páginas), Manual (12 páginas), Manual de documentação técnica (16 páginas), Manual de instruções (16 páginas), Instruções (4 páginas), Manual rápido (2 páginas), Manual de ligação (4 páginas), Manual (4 páginas), Manual (12 páginas), Manual (20 páginas), Manual (15 páginas), Manual de instruções (12 páginas), Manual de início rápido (12 páginas), Manual (16 páginas)

Imprimir página
CAME Z Series Manual
BASIC WIRING
MOTOR CONNECTOR
Cable to
motor 1
W2
Cable to
motor 2
W3
Motor
1
U
V
W
Earth
point
EARTHING
You must create an earthing pointing
in the enclosure to bond the incoming
earth to the two motors and other any
metal gate parts deemed necessary.
MAINS SUPPLY
IEEE regulations designated a drive
as a special location which must be
protected by a RCCB. The supply
should be fused at no less than 6A
and supply cable rated appropriately.
Electrical work is notifiable under P
part of building regulations.
.
www.came.co.uk
MAINS
SUPPLY
Earth
point
Voltage
jumper
240Vac
supply
W1
MOTORS
w1
Frog motors require capacitor in the
control box. M1 capacitor fits to the
black wires, M2 capacitor to the red.
See note r5 for setting Frog direction.
w2
PHOTOCELLS
DIR photocells have plug on screw
terminals. The receiver (Rx) needs a
4 core cable. The transmitter needs a
2 core cable. Set the voltage jumper
to 24V. Range is 10m when the Rx &
Tx face each other within 5 degrees.
Helpline Tel: 0870 012 9000
CONTROL CONNECTOR
DIR
Rx
Photocell
cable
W5
12v
24v
10 2 TX C NC
DIR
Tx
TX 2
BOARD SETTINGS
w3
Leave switch 1 off. Switch 2 is 'on' for
automatic closure. To close the gate
by radio transmitter only, set switch 2
to 'off'. This disables the auto-close.
RADIO CONTROLS
w4
Hang a single core wire 346mm long
from the
is poor, a tuned antenna can be fitted.
Plug the radio head onto the plug (9).
c1
See
TX
link
Photocell
cable
W6
Connect terminal :
ZA4 term 10
to DIR-RX term 10
ZA4 term 2
to DIR-RX term 2
ZA4 term C1
to DIR-RX term C
ZA4 term 2
to DIR-TX term 2
DIR-RX term Tx to DIR-RX term Tx
Aerial
cable
346mm
w5
w6
terminal. If radio range
to set transmitters.
- 2 -