Altman AFS-700 Manual de instalação e do utilizador - Página 13
Procurar online ou descarregar pdf Manual de instalação e do utilizador para Destaque Altman AFS-700. Altman AFS-700 15 páginas. Led follow spot
Imprimir página
INSTALLATION INSTRUCTIONS / INSTRUCTIONS D'INSTALLATION
WARNING! Under no circumstances should the AFS-700 LED Follow Spot be operated with out its fan
filters in place.
If you have any questions regarding the use or care of your AFS-700 LED Follow spot Luminaire,
please contact Altman Lighting technical support or your local Authorized Dealer.
Service and Maintenance
For all other service and maintenance issues, please contact your local Altman Lighting office or an
Authorized Service Center.
WARNING! Disassembly, alterations, unauthorized service, etc. will void the product warranty. Contact
your local Altman Lighting office or an Authorized Service Center for technical support and service.
TROUBLESHOOTING
Troubleshooting Guide
The chart below provides possible causes and remedies for various error messages and/or symptoms. If
this chart is unable to address your issue, please contact your authorized dealer or Altman customer
service at 1.914.476.7987 or [email protected] for assistance.
WARNING! Any service and maintenance (including troubleshooting), other than described herein should
be performed by an Authorized Altman Lighting Dealer or Service Center.
Description
No light output.
Low light output.
No power at luminaire.
DMX Data Control.
Color Wheel does not rotate
to full color frame
Fixtures are running hot
12
Trouble Shooting
Symptom
Possible Cause/Remedy
Fixture will not produce or
Manual Mode....Fader is set at 0% intensity...
output light and connected to
DMX Mode....console is set at 0% intensity...
power. Display is active.
Lamp On/Off is not selected. or fixture calibration is not complete.
Fixture produces low light
Iris is closed
output and connected to
Fixture is Zoomed out and out of Focus
power.
Dimmer is set to low setting
Circuit not energized...verify circuit breaker is turned on.
Not plugged in...ensure A/C cable is connected to power source.
Luminaire does not power up
Power cable wired incorrectly...verify power cable and connector are wired
correctly.
Not detecting DMX data...
Unit is not set to proper DMX address - check settings. See
Address from the Home Screen"
Fixture will not respond to
Unit is not set to DMX mode. See
DMX commands.
Disconnect and reconnect DMX input cable.
Check all DMX connections (at control source and luminaire).
DMX data cable not wired correctly or has a broken conductor... check DMX data
cable for proper wiring.
See
When Color button is
Reset power to the fixture and allow for full calibration of each of the internal
pressed the color wheel
motors. (approx. 90 seconds)
does not rotate to full color
Filters are Dirty.
Using a Philips head screw driver remove the fan filter on the top of the unit.
remove the filter. Clean via dry low velocity compressed air from the underside
of the filter.
AFS-700 LED Follow Spot
for more information.
"DMX Menu"
"Connecting to the DMX512 Network" on page 22
"Setting DMX
for more information.
for more information.