Altman Phoenix Series Manual de início rápido - Página 2
Procurar online ou descarregar pdf Manual de início rápido para Destaque Altman Phoenix Series. Altman Phoenix Series 4 páginas. Ellipsoidal spotlight
Também para Altman Phoenix Series: Manual de operação, programação e segurança (12 páginas)
Imprimir página
INSTALLING THE LAMP
CAUTION: Do not use any lamps exceeding 750W,
or permanent damage will result!
CAUTION: DO NOT touch the glass portion of the
lamp with your hands!
CAUTION: Disconnect xture before re-lamping.
1.
Loosen cap screw until it spins freely.
2.
Pull lamp cap straight out from the luminaire body.
3.
With protective wrap still in place, grasp lamp at base and
gently push into socket until rmly seated.
4.
Remove protective wrap from bulb and replace lamp cap
into luminaire body.
5.
Tighten cap screw.
Cap Assembly
T-Handles
Yoke bolts
Cup Washers
Pivot Covers
Shutter
Lock
Lever
Altman Lighting, Inc.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. COPYRIGHT 2012© ALTMAN LIGHTING, INC. ALL RIGHTS RESERVED.
Shutter Rotation
Lock Knob
Shutter
Short Yoke
Position
Handle
Shutter
Assembly
Lens
Tube
57 Alexander St., Yonkers NY, 10701
LAMP
USING SHORT YOKE POSITION
1.
Remove T-Handle and its associated hardware.
2.
Remove yoke bolts, cup washers and pivot covers. Note:
use a 1/4" hex head wrench to remove yoke bolts.
3.
Stretch yoke and snap it into short yoke position.
4.
Replace pivot covers, cup washers and yoke bolts.
5.
Replace T-Handle into square hole, keeping the washer
between handle and yoke.
ADJUSTING YOKE
1.
With one hand on ring handle to hold unit, loosen T-
Handle.
2.
Tilt unit to desired angle. Note: Reference angles have
been molded on the pivot cover to make adjustments
easier and more precise.
3.
Tighten T-Handle to secure xture in place.
ROTATING SHUTTER ASSEMBLY
1.
Loosen shutter rotation lock knob on either side of the
luminaire.
2.
Rotate shutter assembly 360° in either direction.
3.
Tighten shutter rotation lock knobs to secure shutter as-
sembly.
4.
To lock the shutters in place, rotate the Shutter Lock Lever
until proper tension is applied to shutters.
INSTALLING C-CLAMP
The C-clamp is used to mount the luminaire to a pipe hang
position. The C-clamp attaches to the top of the yoke via
the 1/2" bolt provided with the C-clamp. Be sure to keep the
washer between the bolt head and the yoke.
1-800-4-ALTMAN
CAP
SCREW