Alto Active X-Tra Manual de instruções - Página 8
Procurar online ou descarregar pdf Manual de instruções para Máquina de lavar roupa de pressão Alto Active X-Tra. Alto Active X-Tra 12 páginas.
Imprimir página
7.0 Trouble shooting guide
To avoid unnecessary disappointments, you should check the following before contacting the ALTO serivice
organisation:
Symptom
Machine refuses to start
Machine stops
Fuse blows
Machine pulsating
Machine often starts
and stops by itself
Machine starts, but
no water comes out
Leaky by water inlet
In case problems other than the above occur, please contact your local ALTO distributor.
Customer services (UK only):
ALTO Cleaning Systems Ltd.
Bowerbank Way
Gilwilly Industrial Estate
Penrith, Cumbria CA11 9BN
8
Cause
Machine not plugged in
Defective socket
Fuse has blown
Defective extension cable
Fuse has blown
Incorrect mains voltage
Fuse too small
Air in inlet hose/pump
Inadequate supply of
mains water
Nozzle partially blocked
Water fi lter blocked
Hose kinked
High pressure hoses too long Disconnect high pressure extension hoses
Pump/spray handle is
leaking
Pump/hoses or accessory
frozen
No water supply
Water fi lter blocked
Nozzle blocked
Male coupling not tightened
O-ring damaged
Female coupling not
compatible
Recommended action
Plug in machine.
Try another socket.
Replace fuse. Switch off other machines.
Try without the extension cable.
Replace fuse. Switch off other machines.
Check that the mains voltage corresponds to
secifi cation on the model tag.
Change to an installation higher than the
amp. consumption of the machine.
You may try without the extension cable.
Allow machine to run with open trigger until
regular working pressure resumes.
Check that the water supply corresponds to
specifi cations required (see model tag)
NB! Avoid using long, thin hoses (min 1/2")
Clean the nozzle (see section 4.1)
Clean the fi lter (see section 4.2)
Straighten out hose.
and retry. (Extension hose max. 7 m).
Contact your nearest ALTO Service Centre.
Wait for pump/hoses or accessory to thaw.
Connect inlet water.
Clean the fi lter (see section 4.2)
Clean the nozzle (see section 4.1)
Tighten it up. You may use a pair of pliers.
Contact your nearest ALTO Service Centre.
Try another manufacture.
Phone: 01 768 868 995
EN