Alto LYNX-MIX62 Manual do utilizador - Página 11

Procurar online ou descarregar pdf Manual do utilizador para Equipamento de gravação Alto LYNX-MIX62. Alto LYNX-MIX62 20 páginas.

4. CONTROL ELEMENTS

22 AUX RETURNS

TO MAIN MIX, This control is used to control the volume of the processed

signal sent to Main Mix bus, which can be varied from -

TO AUX1 MON, This control is used to control the volume of the processed

signal sent to Monitor Mix, which can be varied from -

23 MAIN/CD/TAPE

If you push down the CD/TAPE TO CONTROL ROOM button, the CD/TAPE IN

signal will be routed into the Control Room output and the level will be adjusted

by the Control Room knob nearby the Main MIX LEVEL knob.

24 CD/TAPE TO MAIN MIX

If you push down the CD/TAPE TO MAIN MIX button, the CD/TAPE IN signal will be

routed into the MAIN output and will be adjusted by the MAIN MIX LEVEL knob.

25 PHANTOM PWR Switch

This button will apply +48 Volt Phantom Power only to the 2 XLR MIC input

sockets. When condenser microphones are not used, please make sure that

the Phantom Power is disengaged.

26 PHANTOM LED

This LED indicates when the PHANTOM POWER is engaged.

27 POWER LED

This LED indicates when your

DSP SECTION(For LYNX-MIX62FX Model)

There is a powerful 24-bit/16 preset digital multi-effects included in your

MIX62FX

Effects include reverbs, chorus, flanger, delay and combinations of the

above.

28 PRESETS

Adjust this control to select the desired effect.

There are a total of 16 Factory presets available

including WARM HALL, REV+DELAY, REV+CHORUS,

etc.

L YNX-MIX62(FX)

is switched on.

to+10 dB.

to +10 dB.

L YNX-

PRESETS

PEAK

FX MUTE

1. LARGE HALL