3DR Quad Frame Kit Manual de instruções - Página 7

Procurar online ou descarregar pdf Manual de instruções para Quadricópteros 3DR Quad Frame Kit. 3DR Quad Frame Kit 13 páginas. Quadrocopter

Imprimir página

Mount GPS

Place the GPS module onto an accessory plate with the arrow

pointing towards the center of the plate. Use double-sided

foam tape to secure case to plate. Position accessory plate

over the four 30 mm spacers protruding from the APM plate.

Wire additional components to APM

3DR Radio air module:

Attach antenna to 3DR Radio air module.

Connect telemetry cable to the air module pins

(ensuring that the red wire aligns with the pin

marked 5V) and to the APM Telem port.

Radio control (RC) receiver:

To connect an RC receiver to APM, use the five-wire and two-wire cables provided with

your Quad.

Note: APM also supports one-wire PPM connection with supported receivers.

See copter.ardupilot.com for instructions.

Use the five-wire cable to connect the receiver's signal pins to APM's input signal pins.

Use the two-wire cable to connect power and ground pins between APM and the receiver.

APM inputs wiring

After connecting to APM, connect the five-wire cable to the receiver's signal pins (usually

marked "S", see channel diagram below), connect the two-wire cable red wire to a power

pin (usually marked "5V" or "+") on the receiver, and connect the two-wire cable black

wire to a ground pin (usually marked "-") on the receiver.

APM Input Signal Pins

6 AUX 2 (OPTIONAL)

5 AUX 1 (MODE SWITCH)

4 YAW / RUDDER

3 THROTTLE

2 PITCH / ELEVATOR

1 ROLL / AILERON

3DR uBlox GPS with Compass:

Connect the 6-position to 5-position cable to the GPS

6-position port and to the APM GPS port (use top-entry

port not side-entry port). Connect the 4-position cable to

the GPS 4-position port and to the APM I

APM input pin numbers

Connect five-wire cable to signal pins (top row, "S").

Connect red wire to power pin (center row, "+") and

black wire to ground pin (bottom row, "-").

Match the correct control channel

signal pin on the receiver with its

corresponding APM input signal pin.

GPS module

Ensure arrow on

GPS points forward!

C port.

2.6