AkitikA STEREO 416 Manual de início rápido - Página 3
Procurar online ou descarregar pdf Manual de início rápido para Hardware informático AkitikA STEREO 416. AkitikA STEREO 416 11 páginas. Pc30 replacement
Imprimir página
Section 1: About This Manual
This manual gives the information you need to build and install a replacement PC-30 in a
Dynaco Stereo 400/410/416 Power amplifier.
Who Should Attempt this Project?
Warning: The Stereo 400/410/416 is a heavy, awkward beast to work on. It has high
voltages and large capacitors that store a lot of energy. If you're a beginner, don't
install this kit.
Tools You'll Need
You'll need the following tools:
1. flat blade screwdriver for #6 screws
2. needle nose pliers (helpful, but not strictly necessary)
3. pencil type soldering iron of 25 to 50 Watts (no huge honking soldering guns or
blowtorches)
4. wire cutters and strippers
5. Magnifying glass, if you're over 42!
Project Overview
The project consists of the following steps:
1. Building the new PC30 Board.
2. Removing the original PC30 Board.
3. Installing the new PC30 Board.
Important Safety Notes
By purchasing, using, or assembling this kit, you have agreed to hold AkitikA, LLC
harmless for any injuries you may receive in its assembly and/or use. To prevent injuries:
Wear safety glasses when soldering to prevent eye injuries.
Always unplug the power before working on the amplifier.
Large capacitors hold lots of energy for a long time. Before you put your hands
into the amplifier:
o Pull the AC plug!
o Wait 1 full minute for the capacitors to discharge!
Remove jewelry, rings, and watches from your hands and wrists, or anything that
might dangle into the amplifier.
If working in the amplifier, keep one hand in your pocket, especially if you're
near the power supply or power supply wires. This can prevent serious shocks.
Build with a buddy nearby. If you've ignored all the previous advice, they can
dial 911 or get you to the hospital.
Page 3 of 11