ClearCube CD20 Series Manual de início rápido - Página 4

Procurar online ou descarregar pdf Manual de início rápido para Ambiente de trabalho ClearCube CD20 Series. ClearCube CD20 Series 4 páginas. Cloud desktop

Imprimir página
Setting up a Cloud Desktop
Perform the following steps to connect peripherals, a
network cable, and a power supply to the zero client. These
steps assume that the Cloud Desktop, host card, and DHCP
server are on the same network.
NOTE: When connecting to physical devices using a single
monitor or any number of monitors at 2560 × 1600
resolution, install Teradici PCoIP Host Software on the
physical device. (This requirement does not apply to
VMs.) Teradici PCoIP Host Software is available from
Teradici Support. (Note that ClearCube factory images
include Teradici PCoIP Host Software by default).
Ensure that the host driver function on the peer host card
is enabled (it is enabled by default). See Tech Bulletin
TB00274: Configuring Dual-Monitor Systems for Single-
Monitor Use on ClearCube Support for information.
1. Power on the remote Blade PC containing the host card to
which you are going to connect.
2. Connect one or more monitors to the zero client (clients
do not currently support daisy-chaining displays).
3. Connect a network cable to the connector located on the
rear of the zero client (fiber or copper, depending on
model), and then connect the other end of the cable to the
appropriate network infrastructure device (such as a
network switch, fiber transceiver, or router).
Trademarks
ClearCube, Sentral, SmartVDI, Blade Switching BackPack, C/Port, and I/Port are trademarks or registered trademarks of ClearCube Technology, Inc.
PC-over-IP and PCoIP are registered trademarks of Teradici Corporation in the United States and/or other countries.
Kensington is a registered trademark of ACCO Brands.
WEEE Disposal Guidelines
In the European Union, this electronic product is under European Directive (2002/96/EC) WEEE. When
this product reaches the end of its useful life or is no longer used, do not discard it with conventional
waste. Recycle this product at an approved, designated recycling or treatment facility. Check with local
authorities for proper disposal instructions. For assistance, contact [email protected].
ClearCube Technology, Inc.
3700 W Parmer Lane
Austin, Texas 78727
4. Connect a USB keyboard and a mouse to the USB ports
on the front or on the rear of the zero client.
5. Connect the AC power adapter to the power cable
(included with the zero client).
6. Connect the power adapter to the rear of the client, and
then plug the power cable into a power outlet. Ensure that
the zero client and the host card are on the same network.
See "Buttons and Indicators" for information about
powering the zero client on and off.
You can now click Connect and select the host card to
connect to from the list displayed on the OSD.
Configuration Steps and Additional Information
See PC-over-IP System User's Guide and PCoIP Firmware
Support and Compatibility Guide at
information about zero client deployment, configuration,
and administration. If you are using ClearCube Sentral in
your environment, see Sentral Administrator's Guide for
information about connection brokering, device
administration, and more.
Web site:
www.clearcube.com/support
Email:
Toll-free: (866) 652-3400
Phone:
(512) 652-3400
(512) 652-3500
Page 4 of 4
www.clearcube.com
www.clearcube.com
G0200178 Rev B, 1.1.03.14.2017
for