ClearCube V5120 Manual de início rápido
Procurar online ou descarregar pdf Manual de início rápido para Hardware informático ClearCube V5120. ClearCube V5120 2 páginas. Dual host card upgrade kit
Também para ClearCube V5120: Manual de início rápido (2 páginas)
Imprimir páginaV5120 Dual Host Card Upgrade Kit for R1350 Blades
The V5120 Dual Host Card Upgrade Kit for R1350 blades
contains the following items:
V5120 Dual Host card—Provides
dual–monitor support.
Mounting bracket—Connects to motherboard
and to V5120 video card to support the card.
Mounting hardware—Two 6–32 pan–head
screws and two male–female standoffs.
Video V5120 configuration label—Provides
5120
part number, serial number, and card MAC
address. MAC address is critical for card and
blade configuration.
Note: The upgrade kit is for R1350 blades only.
Installing the V5120 Dual Host Card
Perform the following steps to install the V5120 upgrade kit. Use a
#2 Phillips head screwdriver and a ¼–inch hex–head wrench.
CAUTION:
Handle components and cards carefully. Hold cards
and memory modules by their edges and do not
touch their components or contacts. Use a personal
grounding device to prevent electrostatic discharge
before and while installing this upgrade kit.
1.
Remove the R1350 blade from the chassis. If the blade is not in
a chassis, ensure that you disconnect power from the blade.
2.
Remove memory modules and cables to ease access to the
®
®
PCI Express
(PCIe
) video card socket.
a.
Place the blade on a stable surface. Carefully remove
both memory modules by pressing out on the retaining
latches. Place the memory modules on a dissipative
surface, such as the anti-static bag that the V5120 card is
shipped in.
b. Remove the SATA data cable and the hard disk power
cable from the hard disk drive and motherboard.
3.
If the R1350 blade does not contain a video card, skip this
step and continue to step 4.
®
®
If an NVIDIA
Quadro
remove the video card.
a.
Remove the screw from the center of the video card and
save the screw for later use.
ClearCube Technology
Quick Start Guide
4 video card is installed in the blade,
8834 Capital of Texas Hwy N
b. Grasp the video card by the edges. Carefully remove the
card by pulling it out of the PCIe socket. Store the card in
an anti-static bag.
c.
Remove the standoff and the hex–head screw shown in
the following figure (do not use this standoff in the
following step).
Remove
4.
Remove screws and insert standoffs.
a.
Remove the two hex–head screws shown in the
following figure (if you removed a video card in the
previous step, continue to step b).
Remove
b. Insert the two standoffs (included in the kit) in the same
holes. Use a hex–head wrench to gently tighten the
standoffs.
Insert
Austin, Texas 78759
voice 512 652 3500 www.clearcube.com