ACOUSTIC SOLUTIONS KW-TB001 Manual de instruções - Página 7
Procurar online ou descarregar pdf Manual de instruções para Altifalantes ACOUSTIC SOLUTIONS KW-TB001. ACOUSTIC SOLUTIONS KW-TB001 11 páginas. Tower speaker
Imprimir página
Using the FM radio
Wire FM aerial
Please make sure that the wire FM aerial supplied is plugged into the socket on the back of
the Tower speaker and is fully extended before you attempt to tune to an FM station. This
will ensure that the maximum signal strength is available when the Tower speaker begins to
scan. Extending the aerial also ensures the best possible sound quality.
FM Radio mode
If you are not already in FM mode, briefly press and release the silver control ring on the left
hand side (Mode) of the Tower speaker or the 'Input' button on the remote control until you
are in FM mode, (check the display, an FM frequency such as 93.30 will be displayed).
If you were listening to an FM station when you switched the Tower speaker off then this
station will be automatically selected when you switch the Tower speaker back on.
Tuning to an FM station
In FM mode:
Press and release the silver control ring on the right hand side
the
button on the remote control. Your Tower speaker will automatically scan and store
those stations with the strongest signal, up to a total of 25, to its preset memories.
Briefly press and release the silver control ring at the bottom ( ) or top ( ) on your Tower
speaker or the
buttons on the remote control to move through the stored preset
stations (CH01-CH25), until you locate your favourite station.
Note: If FM reception is poor check that the wire aerial is fully extended or try moving the
Tower speaker to another location.
on your Tower speaker or
12
Aux in mode
AUX in mode
Using a 3.5mm audio input connection cable, AUX in allows for a quick and easy connection
to an external sound source.
If you are not already in Aux in mode, briefly press and release the silver control ring on the
left hand side (Mode) on the Tower speaker or 'Input' on the remote control, until you are in
Aux in mode. 'AUX' will be displayed.
Connect one end of a 3.5mm audio connection cable to the headphone (or auxiliary out)
socket of your secondary device, connect the other end to the AUX in socket on the back of
your Tower speaker.
Press the 'Play' button on your external device to start playback through the Tower speaker.
To gain optimal volume levels, adjust the output volume level on both the secondary device
and on the Tower speaker.
Volume (Tower speaker)
Turn the volume control clockwise to increase the volume and anti clockwise to decrease the
volume.
Volume (Remote control)
Volume +
Press and release to increase the volume in steps
Press and hold to progressively increase the volume.
Volume -
Press and release to decrease the volume in steps
Press and hold to progressively decrease the volume.
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021
13