ESI ALL-FLEX FLEX3-WHT-V1 Manual de montagem e operação - Página 4
Procurar online ou descarregar pdf Manual de montagem e operação para Mobiliário de interior ESI ALL-FLEX FLEX3-WHT-V1. ESI ALL-FLEX FLEX3-WHT-V1 12 páginas. 3 leg electric table base
Imprimir página
ALL-FLEX
3 LEG ELECTRIC TABLE BASE
™
STEP 3
Route the side column motor cables under the notch on the angled
portion of each frame.
STEP 4
Install the cross channels.
• Insert each cross channel into the frame and center leg top support.
—
• Slide the top supports under the center leg brackets. Align the holes on the top supports with the 90° or
120° holes in the brackets. See the illustration below.
• Position each cross channel so that its center line is centered between the frame and the top support.
• The MAX lines must not extend beyond the frame and top support.
MAX
Frame
STEP 5
Attach the top supports to the center leg brackets.
• Use the 4mm Allen key and four M6x15 hex head
screws.
• Use the inner hole on the bracket for 90° tables
and the outer hole for 120° tables.
4
Cross Channel
Rear
Center Line
MAX
Set Screws
Cross Channel
Center Leg
Bracket
Top Support
Top Support
M6x15
ASSEMBLY
Route Cable
Under Notch
120°
90°
4mm
Allen
Key
Top
Support