ABC PROIZVOD VOLCANO Manual do utilizador - Página 9

Procurar online ou descarregar pdf Manual do utilizador para Fogão ABC PROIZVOD VOLCANO. ABC PROIZVOD VOLCANO 12 páginas. Solid fuel stove 24kw

6.2. OPERATION

Fireplace is fired as all continually heated solid fuel boilers. When you open the burner

door of the fireplace, put some paper on the grate, wood, cut in pieces and fire it up.

Then, gradually put heating material until fire becomes larger. After that, fill in the

burner, position ashtray behind limiter, close fireplace door an set draught regulator to

the desired temperature.

On the fireplace casing, Fig. 1 pos. 3 there is installed draught regulator, which has the

function to set desired temperature and is consisted of numerically marked wheel from

0 - 9, regulator flap and capillary. Draught regulator is capillary connected with probe

whereat it collects data about water temperature in the fireplace. Temperature in

fireplace is the lowest when draught regulator button (fig. 1. pos. 3) on number 1 (fig.

1a), and the highest on number 9 (fig. 1 b). When temperature begins to drop, regulator

flap automatically opens 3-5 mm, which enables flow of secondary draught (air) and

better combustion up to the desired temperature. Setting of draught regulator depends

on desired ambient temperature.

Important note:

In order to make draught regulator work properly, it is necessary to connected fireplace

to the chimney of proper dimensions. Space between regulator flap and opening for

airflow must be cleaned from time to time and to remove residual ash and other

combustion products. Avoid low water temperatures in the fireplace, 50-60°C, because

it may lead to condensation. If you notice any water collection in the ashtray, just

increase fireplace operating temperature.

IMPORTANT: Do not leave product with open door unattended and ashtray must

be in the position behind limiter – completely closed, since it may lead to

uncontrolled increase of temperature above allowed level.

Technical problems may occur due to following reasons:

a) Due to possible factory-based defects – in such case, contact the manufacturer

,,ABC PROIZVOD",

b) Due to defects at installation and connecting – in such case, contact the technician,

c) As the consequence of improper handling, non-observance of proper heating mode

and fireplace maintenance by the user – in such case, please read again this manual

and proceed properly,

If after all above mentioned problem persists, contact the factory ,,ABC PROIZVOD" for

advice/intervention.