ClearOne WS800 Manual de início rápido - Página 4

Procurar online ou descarregar pdf Manual de início rápido para Sistema de microfone ClearOne WS800. ClearOne WS800 10 páginas. Wireless microphone system antenna application guide
Também para ClearOne WS800: Manual de início rápido (15 páginas), Manual (5 páginas), Manual de início rápido (13 páginas), Manual de aplicação (12 páginas), Manual de aplicação (11 páginas)

How to sync transmitters with the receiver:

1. Locate the IR (infrared) Sensor on the transmitter.

2. Power on the transmitter.

3. Hold transmitter about 6 inches from the corresponding receiver module with the IR sensor aimed at the

receiver module.

4. Simultaneously press the two buttons on the bottom of the corresponding receiver module to start sending

the IR signal. "SYNCING" shows on the receiver OLED when the IR signal starts. "SYNC OK" shows

when the sync is successful. Repeat the procedure if the receiver display shows "SYNC FAILED". It is not

necessary to press any buttons on the transmitter during the procedure. Note: You may get a "Sync Failed"

message if the receiver antennas are not in the same room as the receiver. In this case verify that either the

transmitter display shows "Sync Good" OR the green LED on the transmitter flashes. Also make sure to dock

each transmitter after syncing to avoid 2 transmitters being synced to the same receiver frequency.

How to read the LED:

1. The Gooseneck or

Boundary Mic is in use:

RED = AUDIO MUTE

GREEN = AUDIO PASSES

BLINKING RED = BATTERY IS LOW

BLINKING GREEN = SYNC SUCCESSFUL

NOTE: All transmitters placed in the charging dock will "RF MUTE".

ON/OFF

USB

2. The Gooseneck Battery Cassette and

USB

ON / OFF

NOTE: The transmitter and receiver are assigned a new,

random AES 256-bit encryption key every time they are synced.

Boundary Mic are in the docking

RED = CHARGING

OFF/OR GREEN = FINISHED CHARGING

BLINKING RED = CHARGING ERROR (RE-SEAT THE

TRANSMITTER AND CHECK THE BATTERIES)

3. When the Hand-held Mic and the

station:

Belt-pack are in the Docking Station:

The OLED shows

the battery status