ClearSounds CL1100 Manual de instalação e manual do utilizador - Página 8
Procurar online ou descarregar pdf Manual de instalação e manual do utilizador para Telefone ClearSounds CL1100. ClearSounds CL1100 18 páginas. Clearsounds communications amplified telephone installation guide & user manual cl1100
Imprimir página
Wall Mount Use
1. Slide the handset hanger tab out and reverse its position (rotate it 180 degrees).
Slide it back into place so that the hook points up
handset from falling out of the cradle when it is mounted on the wall.
2. Insert the Wall Plate adapter
line should run underneath the wall-mounting bracket.
3. With the Wall Plate adapter installed, plug the 8in short phone cord into the telephone
jack on the CL1100 and then into the jack on the wall.
4. Holding the phone slightly above the mounting screws on the wall jack, push the
phone against the mounting screws so they are hooked into upper and lower key-
hole slots on the back of the phone. Slowly slide the phone down until it snaps into
place
(See diagram #6)
5. Connect the handset coil cord (curly cord) to the handset and to the telephone.
6. Lift the handset and listen for a dial tone. If you hear a dial tone, your phone is ready
to use. If there is no dial tone, check all your cords to make sure they are plugged in
securely.
DIAGRAM #4 – Reversing the hook
PROGRAMMING MEMORY DIAL BUTTONS
Your CL1100 Phone holds 12 programmed Memory Dial Buttons.
To program your one-touch memory dial buttons please follow instructions below:
1. Lift the handset.
2. Press the PROG button
3. Press one of the 12 Memory Dial buttons (M1 - M12) located on top of the phone
(See diagram #8)
same procedure) for a phone number up to 21 digits long.
4. Using the keypad, dial the number you would like to save, including 1 and the area
code (if applicable).
5. Press the PROG button again
6. To register your stored phone numbers, use the erasable phonebook card located
on the top of your phone. IMPORTANT: The phonebook card is non-removable.
Simply use a clean pencil eraser to make changes.
8
(See diagram #5)
.
DIAGRAM #6 – Wall installation
(See diagram #7).
. Each button can be programmed (or reprogrammed using the
(See diagram #9).
(See diagram #7).
(See diagram #4).
. It snaps into place. The cords phone
DIAGRAM #5 –Wall plate installation
This will keep the