Altos AcerAltos City850 Manual do utilizador - Página 2

Procurar online ou descarregar pdf Manual do utilizador para UPS Altos AcerAltos City850. Altos AcerAltos City850 5 páginas. Line-interactive ups

OVERVIEW

The UPS provides automatic voltage regulation for inconsistent utility power, and provides battery

backup during power outages, and ensures consistent power to your computer system.

HARDWARE INSTALLATION GUIDE

1. Your new UPS may be used immediately upon receipt. However, recharging the battery for at

least 8 hours is recommended to ensure that the battery's maximum charge capacity is achieved.

Charge loss may occur during shipping and storage. To recharge the battery, simply leave the

unit plugged into an AC outlet. The unit will charge in both the on and off position.

2. With the UPS unit off and unplugged, connect the computer, monitor, and any externally

powered data storage device (Zip drive, Jazz drive, Tape drive), etc. into the battery power

supplied outlets. DO NOT plug a laser printer, copier, space heater, vacuum, paper shredder or

other large electrical device into the battery power supplied outlets. The power demands of these

devices will overload and possibly damage the unit.

3. Plug the UPS into a 2 pole, 3 wire grounded receptacle (wall outlet). Make sure the wall branch

outlet is protected by a fuse or circuit breaker and does not service equipment with large electrical

demands (e.g. air conditioner, refrigerator, copier, etc. Avoid using extension cords.

4. Press the power switch to turn the unit on. The power on indicator light will illuminate and the

unit will "beep".

5. If an overload is detected, an audible alarm will sound and the unit will emit one long beep. To

correct this, turn the UPS off and unplug at least one piece of equipment from the battery power

supplied outlets. Wait 10 seconds. Make sure the circuit breaker / fuse is normal and then turns

the UPS on.

6. To maintain optimal battery charge, leave the UPS plugged into an AC outlet at all times.

7. To store your UPS for an extended period, cover it and store with the battery fully charged.

Recharge the battery every three months to ensure battery life.

BASIC OPERATION

Front panel

1. Power Switch

Press the switch for 2 seconds to turn the UPS ON or

OFF.

Mute setting: The audible alarm can be turned OFF or

ON by quickly pressing the power button twice. The

default setting is for the Alarm On.

2. Line Mode LED

The green LED will light when utility power is normal.

3. Battery Mode LED

The yellow LED will light when input power is

abnormal and the unit will work in battery mode.

4. Fault LED

The red LED will light when fault or over load occurs.

Page 2 of 5

Models:

1200/1500/2000

Models:

650/850

Version: 2020/07