Altox GSM-4 GPS Manual de operação

Procurar online ou descarregar pdf Manual de operação para Unidade de controlo Altox GSM-4 GPS. Altox GSM-4 GPS 4 páginas.

General Guide for Installation

- Install the device as far as possible from metal parts and wiring

Altox

harnesses.

- For better receiving of GPS-GLONASS signals direct the upper part of the

device casing to the windshield minding metal obstacles.

- Recommendation: connect device supply directly to the OBD-II connector

wires where pin 16 is +12В, pin 4 is GND (common).

- Analog output AN commutates at GND. It is used to start some heaters

using an analogous signal and to connect status LED located in the button

from the package.

- Auxiliary output OUT commutates at GND. It is used to connect a coolant

pump or the interior's heater via a power relay. It is switched on with the

delay (see SMS-command TIME2) after the heater is switched on. It is

switched off with the delay (see SMS-command TIME3) after the heater is

switched off.

- If you need to implement additional options of remote control of output

OUT (for example, to block engine remotely) activate setting SEPAROUT1.

It switches the output mode into manual control mode (SMS-commands:

O p e r a t i o n a l M a n u a l

ACTIVATE / DEACTIVATE).

In this mode setting KEEPOUT1 activates option to save and to

subsequently restore of output OUT state when the module's power supply

is switched off and then switched on, respectively.

ALTOX GSM-4 GPS

Please indicate the place of ALTOX module's location in the vehicle for

possible maintenance:

Authorized Service:

Installation Date: