ClearSpan CL108543 Manual - Página 16

Procurar online ou descarregar pdf Manual para Tenda ClearSpan CL108543. ClearSpan CL108543 17 páginas.

Imprimir página
CLEARSPAN
FABRIC STRUCTURES
™
TIGHTEN THE SIDE RATCHETS
Verify that the cover is in the desired position and centered on the frame.
(Loosen and reposition if needed.) Continue with these steps to tighten the side
ratchets.
1.
Move to the side ratchets attached to each leg of one rafter. Begin at an
inside rafter near the center of the frame.
2.
With an assistant at one side ratchet and someone at the other side ratchet
on the same rafter, tighten the ratchets to secure the cover.
Tightening the ratchets at the same time on the same rafter helps keep the
cover centered and results in a more uniform appearance.
3.
Move to another rafter and repeat the steps to tighten the side ratchets
attached to that rafter.
NOTE: If the strap builds up in the ratchet, loosen the ratchet, remove some
of the strap, and retighten.
4.
After all side ratchets (QH1065) are tight, position someone at each ratchet
attached to the end rafter where the bonnet straps of the cover were
previously inserted.
NOTE: Cover shown
may differ from the
actual cover for your
building.
Photo shows the
QH1061 ratchet
attached to the end
rafter. QH1061 is
used to secure the
bonnet portion of the
main cover.
5.
Tighten the end ratchets to secure the bonnet portion of the main cover.
6.
Move to the other end of the building and secure the bonnet at that end.
16
Main Cover
Bonnet
Space below is reserved for customer notes.
Revision date: 09.08.09