ClearSpan PB02000R4N Manual de instruções - Página 9

Procurar online ou descarregar pdf Manual de instruções para Tenda ClearSpan PB02000R4N. ClearSpan PB02000R4N 13 páginas. Round style mini garage

Imprimir página

ATTACH END CONDUIT ASSEMBLIES

1. Place the end conduits of end panels in position.

2. Insert the bottom of the end rafters into the short tee

of the end conduit.

3. Tighten the Allen screws to secure the short tee to

the end rafter.

End

Rafter

Short

Tee

Allen

Screws

Figure 13. Attaching the End Conduit

ANCHOR THE SHELTER

At this point, you must anchor the shelter. Consult the

MUST READ document for anchoring information and

suggestions. Please call customer service at

1-800-245-9881 for additional anchoring information.

! CAUTION: The anchor assembly is an integral part of

the shelter construction. Improper anchoring can cause

shelter instability and failure of the structure to perform

as designed. Failing to anchor the shelter properly will

void the manufacturer's warranty and can cause serious

injury and damage.

Visit www.ClearSpan.com for additional products and customer assistance.

ATTACH END PANEL ASSEMBLIES

Gather the Parts

Assembly Procedure

Purlin

End

Conduit

3. Moving outward in both directions, place fabric clips

4. Secure each fabric clip to end rafter with a Tek

NOTE: Your end panels may have been shipped as

untrimmed rectangular pieces. If so, use scissors to trim

the excess end panel material inside the shelter to an

inch or two past the fabric clip as shown in Figure 14.

5. Secure the zippered end panel in place using

•

End Panel Assemblies (2)

•

Fabric Clips (#CC6212)

•

Tek Screws (#FA4482B)

•

Measuring Tape

•

Scissors

1. While standing inside the shelter, start at the peak of

the end rafters and pull the solid (plain) end panel

over the top of the rafter so the material edge is on

the inside of the rafter.

2. Secure the solid end panel in place at the top center

of end rafter with a fabric clip and Tek screw.

spaced evenly on rafter.

screw (on side where it will not contact cover).

Figure 14. Securing Fabric Clips

fabric clips with Tek screws as you did on the

plain end panel in Steps 1-4.

8 of 12