ClearSpan R030A00008 Manual - Página 5

Procurar online ou descarregar pdf Manual para Tenda ClearSpan R030A00008. ClearSpan R030A00008 13 páginas. Twin-wall polycarbonate end panel kit 30' wide & 35' wide

Imprimir página

END PANEL INSTALLATION

The steps that follow describe one way to complete the

polycarbonate panel installation. The materials and parts

needed to install the polycarbonate panels include:

•

Polycarbonate panels and vent tape (104774)

•

Aluminum H-channel (#104212) and aluminum

U-channel profile (#104213)

•

Tek screws (#FA4484B) and neo-bonded, galvanized

washers (#102921B)

Read the following information before starting:

•

U-channel (104213) is used to finish the two (2)

outside polycarbonate panel edges.

•

H-channel (104212) is used to join polycarbonate

panels at the seams.

•

Tek Screws and neo-bonded washers are used to

secure aluminum channel and panels to end wall

frame.

•

Install the polycarbonate panels with the UV-protected

side to the outside. Mark this side with a marker if

needed after removing the protective film.

ATTENTION: Remove the protective film from the

polycarbonate panels. Do not stack panels in direct

sunlight. Allowing the film to remain intact and in direct

sunlight will make the film difficult if not impossible to

remove.

•

During preparation, rest the edges of the panels on

cardboard or other material to protect them from dirt

and damage.

•

Do not install panels on a windy or stormy day or

when such conditions are expected.

•

Consult the polycarbonate panels (Quick Start

section) for the location and lengths of each panel.

The diagrams are located at the back of these

instructions.

ATTENTION: Position panels as shown on the panel

diagrams. Using a panel in the incorrect place can affect

the placement of subsequent panels. In addition, the

amount of aluminum profile used between panels may not

be adequate if additional seams are created.

Install all accessories (fans, vents, heaters, etc.) after

installing all polycarbonate sheets.

If a door was purchased, review those instructions

and position panels as needed to accommodate the

door position and installation.

Revision date: 06.02.09

End Panel Installation

Install panel cells vertically to allow condensation to drain

from the cells. Consult the polycarbonate panels diagrams

located in the Quick Start section for panel locations and

details for the 30' and 35' wide end walls. Complete the

following steps to install the end panels.

Working from the center of the end wall, take one

panel, remove the protective film, and mark the UV-

protected side as a reminder to install this side toward

the sun. Check diagrams in the Quick Start section.

Always remove the protective film and mark and

install the UV-protected side to the outside of the

greenhouse.

Using the 104774 vent tape, tape the open cells as

described below.

Apply tape to the lower end

of all lower panels and to

the upper end of all upper

panels to seal the cell

openings.

The two outer panels that

span from ground level to

the end rafter are taped at

the top and bottom.

Take H-channel and attach to the outer edges of the

panel and flush with the top and bottom of panel.

Lower Panel:

4'x8' (30' wide)

6'x8' (35' wide)

Consult the

diagrams in

the Quick

Start section

104212

H-Channel

identification.

Vent Tape

Mark UV Side

Vent Tape

Panel

for panel

104212

H-Channel