ClearSpan R030B00007 Manual - Página 4

Procurar online ou descarregar pdf Manual para Tenda ClearSpan R030B00007. ClearSpan R030B00007 11 páginas. Corrugated polycarbonate end panel kit 30' wide & 35' wide

Imprimir página
ASSEMBLY PROCEDURE
Following the instructions as presented will help ensure
the proper installation of the end panels. The steps
outlining the assembly process are as follows:
1.
Verify that all parts are included in the shipment.
Notify Customer Service for questions or concerns.
2.
Read these instructions, the Must Read document,
and all additional documentation included with the
shipment before you begin.
3.
Gather the tools, bracing, ladders (and lifts), and
assistance needed to install the end panels.
4.
Check the weather
before you install the panels. Do
not install panels on a windy or stormy day or when
such conditions are expected.
5.
Install the panels.
6.
Read the care and maintenance information at the
end of these instructions.
7.
Complete and return all warranty information as
instructed (if equipped).
UNPACK AND IDENTIFY PARTS
The following steps will ensure that you have all the
necessary parts before you begin.
1.
Unpack the contents of the shipment and place
where you can easily inventory the parts. Refer to the
Bill of Materials/Spec Sheets.
2.
Verify that all parts listed on the Bill of Materials/Spec
Sheets are present. If anything is missing or you
have questions, consult the parts guide on the next
page and all shelter diagrams for clarification, or
contact customer service.
NOTE: At this time, you do not need to open the
plastic bags containing smaller parts such as
fasteners and clamps.
QUICK START GUIDE
For a quick overview of the end panel kit and its
components, consult the Quick Start Guide located at the
back of these instructions. Diagrams in the Quick Start
section show frames with sidewall panels installed.
ATTACHING THE PANELS
When setting the panels in position, remember to install
each panel with the UV-protected surface facing toward
the outside. Read the information printed on each panel.
4
Important Information
PARTS IDENTIFICATION
The following graphics and photos will help you identify
the different parts. (Some parts are not shown.)
FA4482B
Tek Screw
100441
Nut Setter
102921B
Neo-bonded
Galvanized Washers
104620C (50" x 8' 2") and/or
104621C (50" x 12' 2")
Corrugated Polycarbonate Panels
Revision date: 06.04.10