AIMS POWER PWRI100012120S Manual do utilizador - Página 4
Procurar online ou descarregar pdf Manual do utilizador para Inversor AIMS POWER PWRI100012120S. AIMS POWER PWRI100012120S 6 páginas. Dc to ac pure sine wave inverter
Imprimir página
5
3 / "
8
3. Assemble the remote control box(Optional equipment)
P
AIMS
OWER
TM
www.aimscorp.net
1) the remote is designed to be mounted on a dash or other surface where a hole
should be cut so that it sits flush. This is not a requirement however just a
recommendation.
2) The remote cable should be plugged into inverter and the remote before mounted.
Note: Optional remote is not needed for inverter operation. The main power switch
will work the power on / off
11 "
4
Check the output voltage and capacity of the battery,it should comply with the
requirement of the product used (12 volts).
Connect your inverter to your battery bank, but be sure not to reverse the polarities of
the connection.
Press the power on button on your inverter for .5 seconds and a green LED will
light up indicating that the inverter is on. The remote also has an on indicator light.
Before plugging anything into your inverter, make sure the appliance you're trying to
power is shut OFF, then plug it into the AC outlet of your inverter and power on your
appliance.
Once finished using the inverter, turn off your electrical appliance and the inverter.
Also, if you do not plan to use the inverter for a long period of time, disconnect it from
your battery bank.
6.
The cooling fan on this product will not run on start up. It will start when the inverter's
case reaches about 40
℃.
Again, be sure to turn off the inverter when it's not in use. Accidentally leaving the
inverter on for a long period of time could result in damaging the product. It may
also over discharge your battery battery back causing permanent damage.
7.
The USB port on this unit can provide a stable line of 5V DC current. The maximum
current is 1000 mA. Be sure to double check your device to make sure it doesn't
exceed these requirements.