ClearSpan Premium Solar Star 104918 Manual de instruções de montagem - Página 5

Procurar online ou descarregar pdf Manual de instruções de montagem para Kit de estufa ClearSpan Premium Solar Star 104918. ClearSpan Premium Solar Star 104918 17 páginas. Home-attached greenhouse

Imprimir página

After all parts are identified, the site is prepared, and the

Must Read document is read, assemble the base for the

greenhouse. The following steps describe one way to

assemble the greenhouse.

RECYCLED PLASTIC BASE BOARDS

ATTENTION: The longer boards may exceed 96".

Measure and cut these to 96" if needed.

The front and back/open side base assemblies are

identical. Each includes two (2) lengths of plastic lumber:

•

1 section @ 44"

•

1 section @ 96"

The two end base assemblies are identical. Each

includes two (2) lengths of plastic lumber:

•

1 section @ 32"

•

1 section @ 96"

The boards for the recycled plastic base are positioned

end-to-end. The joints are not secured with any

brackets. See the following diagrams.

Back/Open Side

32"

Front

Door (or

Non-Door)

End

Visit www.ClearSpan.com for additional products and customer assistance.

44"

Front Board

NOTE: The front and back base boards are positioned

between (or to the inside) of the door and non-door end

base as shown to achieve the required length and width.

This base can be placed on the site before or after

assembling the metal base.

The metal base is attached to the plastic lumber base

using A-Angle brackets after the panels are secured to

the metal frame. This prevents placing the A-Angled

brackets in a position that interferes with the installation

of panel brackets.

ASSEMBLE THE METAL FRAME BASE

Locate the following brackets and tubes needed to

assemble the frame base:

Required tubes for each side/end:

Front and Back/Open: 1 length @ 48" (plain)

Door End:

Non-Door End:

1. Assemble the metal frame as shown below:

Back (or Open) Side

Door End

NOTE: Do not seat the plain pipe tightly to the swaged

pipe. The separate pipes must be allowed to adjust

outward during assembly to allow proper panel fit.

104636 Corner Bracket

1 length @ 99" (swaged)

1 length @ 25" (plain)

1 length @ 61" (plain)

1 length @ 27" (plain)

1 length @ 99" (swaged)

Non-Door

End

Front

4 of 16