ClearSpan R030A00007 Manual - Página 5

Procurar online ou descarregar pdf Manual para Kit de estufa ClearSpan R030A00007. ClearSpan R030A00007 11 páginas. Corrugated polycarbonate end panel kit 30' wide & 35' wide

Imprimir página

END PANEL INSTALLATION

The steps that follow describe one way to complete the

end wall panel installation.

The materials and parts needed to assemble the end

panels include:

•

Corrugated polycarbonate panels (#104621C)

•

Tek screws (#FA4482B)

•

Neo-bonded washers (#102921B)

Read the following information before starting:

•

Tek screws and neo-bonded washers are used to

secure panels to end wall frame.

•

During preparation, rest the edges of the panels on

cardboard or other material to protect them from dirt

and damage.

•

Consult the polycarbonate panels (Quick Start

section) for the location and lengths of each panel.

The diagrams are located at the back of these

instructions.

ATTENTION: Panels must be positioned as shown on the

panel diagrams. Using a panel in the incorrect place can

affect the placement of subsequent panels.

Install all accessories (fans, vents, heaters, etc.) after

installing all polycarbonate sheets.

If a door accessory was purchased, install the

door before attaching the end panels. Adjust the

panel position as needed to accommodate the door

installation. Consult the door installation manual (if

present) for additional details.

Complete the following steps to install the end wall panels.

Consult the polycarbonate panels diagrams located in the

Quick Start section, select one panel, begin at the edge

of the end wall, and work toward the opposite edge of the

end wall.

NOTE: Set end panels in a position that prepares for the

installation of the sidewall panels if equipped. This may

include shifting the outside panels beyond the end rafter

leg/ground post so corner panels align with each other.

Revision date: 04.13.09

End Panel Installation

Set the first 50" x 12' 2" panel in place as shown with

the side edge aligned with the center of the end rafter

and the bottom edge flush against the ground. Do not

attach at this time.

Trim excess

panel

50" x 12' 2"

Panel

Actual end frame may differ from frame shown; end panel

installation is the same. Consult the panel diagrams located

in the Quick Start section for your end panel kit.

Trace along the end rafter to mark where the panel

needs to be cut to fit into the end cap.

End Cap

Position top of

end panels here

Remove panel, cut along traced line, and set panel

back into position by tucking the top edge under the

end cap. Do not damage panel section cut from main

panels; these may be used in another position.

Verify that the panel is flush with the ground and that

the outer edge is aligned so that it creates a finished

corner with the sidewall panels (if equipped) when

these are installed. Attach panel to the end frame.

Brace panel in correct position

and trace a line along the end

rafter. Remove panel and cut

to fit.

Adjust panels as needed to

create a finished corner joint

where end panels meet sidewall

panels. See arrows to the left.