Dixon Systems RM-35 Manual do Proprietário - Página 5

Procurar online ou descarregar pdf Manual do Proprietário para Monitor Dixon Systems RM-35. Dixon Systems RM-35 8 páginas. Stereo rack monitor

Dixon Systems

1-8 Set Up:

The RM-35 can be set up in a few easy steps. Once the unit has been inspected,

slide and secure the monitor into the rack. Connect the audio signals via XLR or

quarter inch TRS connectors. Plug the unit into the AC mains. (The RM-35 operates

from 110VAC - 60Hz power.)

Adjust the volume control on the rear panel. The RM-35 is designed to be driven by

a balanced source at a nominal +4 dB level. When used with the NM-250, the volume

control on the RM-35 should be at approximately 'one o'clock'. If used with another

audio source, be sure the monitor is not over-driven. AVOID CLIPPING! Audible

distortion (or other nasty things) will occur.

Best performance is achieved when using balanced, shielded cable; however

satisfactory results can sometimes be realized without it. The design of the input stage

permits unbalanced sources to be applied to the balanced inputs. The drawings below

show both balanced and unbalanced connections. (Only one channel is shown.)

Balanced

Unbalanced

Note: When using balanced line, only one end of the line should be grounded. This

will help avoid ground loops. As shown above, the ground would be connected at the

'send' end and not connected to the RM-35.

Input Impedance:

Load Impedance:

Maximum Output Level

Gain:

Frequency Response:

Total Harmonic Distortion:

Noise:

Power Requirements:

40kOhms

8 Ohms

> 1 W per Ch. RMS

Adjustable

< .5 dB 20 Hz to 20 kHz

Better than .5%

Better than 90 dB

110 VAC/ 60 Hz 15 W

Model RM-35