Edgewater Networks EdgeProtect 7300 Manual de instalação do hardware - Página 10

Procurar online ou descarregar pdf Manual de instalação do hardware para Controlador Edgewater Networks EdgeProtect 7300. Edgewater Networks EdgeProtect 7300 18 páginas. Enterprise session border controller 7000 series
Também para Edgewater Networks EdgeProtect 7300: Manual do hardware (16 páginas)

Imprimir página

Rack- Mount Installation

You can install the EdgeProtect 7300 in a 19" rack using the rack mount kit supplied with

the product.

IMPORTANT

Before installing the EdgeProtect 7300 in a rack, take note of the following

conditions:

Elevated Operating Ambient Temperature - If installed in a closed or multi-unit rack

assembly, the operating ambient temperature of the rack environment may be greater than

room ambient. Therefore, consideration should be given to installing the equipment in an

environment compatible with the maximum ambient temperature specified by the

manufacturer.

Reduced Air Flow - Installation of the equipment in a rack should be such that the amount

of airflow required for safe operation of the equipment is not compromised.

Mechanical Loading - Mounting of the equipment in the rack should be such that a

hazardous condition is not achieved due to uneven mechanical loading.

Circuit Overloading - Consideration should be given to the connection of the equipment

to the supply circuit and the effect that overloading of the circuits might have on

overcurrent protection and supply wiring. Appropriate consideration of equipment

nameplate ratings should be used when addressing this concern.

Reliable Earthing - Reliable earthing of rack-mounted equipment should be maintained.

Particular attention should be given to supply connections other than direct connections to

the branch circuit (e.g. use of power strips).

To install the EdgeProtect in a rack:

1. Attach the rack mount ears to both sides of the EdgeProtect chassis with the supplied

screws.

2. Install the chassis in the rack with rack mount screws (not included).

Connecting the Power and Cables

The EdgeProtect 7300 comes with an AC power cord for connecting the unit to the AC

outlet.

Warning

Always connect the AC power cord to an AC outlet suitable for the power supply

per the Power specifications listed in this document in order to reduce the risk of

damage to the EdgeProtect 7300 power supply.

1. Connect one end of the AC power cord to the EdgeProtect 7300 input power socket

and the other end to the AC outlet. You may need to apply a bit of force to properly

position the plug in the power socket.