ClearView SD4650 Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Modulador ClearView SD4650. ClearView SD4650 12 páginas. Dvb-t hd modulator

2 INSTALLATION

One SD4650 Encoder / Modulator

The SD4650 unit comes standard with, Component, and Composite video inputs.

Component Connection: Connect the Y (Green), Pb (Blue), and Pr (Red) video source cable

to the unit's Component input ports. If using a Composite Video source, use a 75Ω coaxial

cable with RCA connectors to connect the video source to the unit's CVBS port.

Use RCA cables to connect the audio source to the red / white AUDIO L and AUDIO R INPUT

jacks.

Use a quality 75Ω coaxial cable with "F" connectors from the unit's RF OUT jack to the

distribution system or directly to a television.

Connect the power cord to an appropriately rated AC power outlet.

Once connected to power, the device turns on and it takes about 20 seconds to be

operational. Then the message "Initial Please wait" appears on the display. After 60 seconds

the message " IP Address 192.*.*.*" on the display.

Connect an Ethernet cable directly (no Cross Over cable required) to the Ethernet Port on

the rear panel of the encoder or connect the Ethernet cable to an Ethernet switch. Connect

an Ethernet Cable to your PC.

Please inform your engineer have accessed SD4650 over the internet via a switch / router.

ll parameters could be stetted by web UI, you could view the value through front panel,

but could not change the parameters value via key pad of front panel.

SD4650 Manual Rev 1.0