EdgeWave iPrism Instalação num bastidor - Página 2

Procurar online ou descarregar pdf Instalação num bastidor para Servidor EdgeWave iPrism. EdgeWave iPrism 3 páginas. Models 15h;models 25h;models 35h;models 55h; models 105h;
Também para EdgeWave iPrism: Manual do hardware (12 páginas)

Imprimir página

Installing the System into a Rack

This section provides information on installing the St. Bernard server appliance into a rack unit with the rack rails provided.

There are a variety of rack units on the market; the assembly process for each will differ slightly. You should also refer to the installation instructions

that came with the rack unit you are using.

Identifying the Sections of the Rack Rails

You should have received two rack rail assemblies in the rack mounting kit. Each assembly consists of two sections: an inner ﬁxed chassis rail

that secures directly to the server chassis, and an outer ﬁxed rack rail that secures directly to the rack itself (see Figure 1).

Two pairs of short brackets to be used on the front side of the outer rails are also included.

Installing the Inner Rails

Both the left and right side inner rails have been pre-attached to the chassis. Proceed to the next step.

Figure 1: Identifying the Sections of the Rack Rails (right side rail shown)

Installing the Outer Rails

Begin by measuring the distance from the front rail to the rear rail of the rack. Attach a short bracket to the front side of the right outer rail and a long bracket

to the rear side of the right outer rail. Adjust both the short and long brackets to the proper distance so that the rail can ﬁt snugly into the rack.

Secure the short bracket to the front side of the outer rail with two screws and the long bracket to the rear side of the outer rail with three screws.

Repeat these steps for the left outer rail.

Locking Tabs

Both chassis rails have a locking tab, which serves two functions. The ﬁrst is to lock the server into place when installed and pushed fully into the rack,

which is its normal position. Secondly, these tabs also lock the server in place when fully extended from the rack. This prevents the server from coming

completely out of the rack when you pull it out for servicing.

Figure 2: Installing the Rack Rails

Installing the Server into the Rack

You should now have rails attached to both the chassis and the rack unit. The next step is to install the server into the rack. Do this by lining up the rear of the chassis

rails with the front of the rack rails. Slide the chassis rails into the rack rails, keeping the pressure even on both sides (you may have to depress the locking tabs when

inserting). See Figure 3.

When the server has been pushed completely into the rack, you should hear the locking tabs click.