DIZHUO DB2200A/W Manual de operação, instalação e manutenção - Página 8

Procurar online ou descarregar pdf Manual de operação, instalação e manutenção para Máquina de gelo DIZHUO DB2200A/W. DIZHUO DB2200A/W 15 páginas.

Imprimir página

1.5Unpacking

①Before unpacking, check whether the outer packing

machine is well and the machine model is consistent

with you purchased.

②Remove the shipping tape on the door and evaporator

(ice tray)

③Remove the protective film on the shell.

Remove the attachment and check the

type and quantity

Plastic adjustment foot 4 pieces（DB75A/W, DB95A/W,

DB125A/W plus 4 counter installation foot）

Plastic ice scraper

Inlet pipe

Drain pipe

Drain pipe clamp

Specification

Warranty card

1.6 Choose installation location

The ice maker is not suitable for outdoor use , don't

get close to the location of the source of heat or direct

sunlight.

Working environment temperature should be5 ℃ ~ 38

℃,the normal work of the water temperature should be

5 ℃ ~ 35 ℃ . If the ice machine long time work beyond

the normal working temperature range , may affect ice

-making capacity.

Ice machine should be installed in a solid, flat ground.

Don't put any items in front of the ice machine ventilation

window.

Ice machine can not work in sub-zero temperatures. To

prevent water supply line fault , when air temperature

is below freezing , please drain the water in the ice

machine (see "preparations for long-term storage of

ice machine").

1.7The ice maker level adjustment

Adjust the four foot adjustable part twist in the end,

andthen adjust the foot twist into ice machine bottom

corresponding installation hole.

Move the ice machine to install location.

Use spirit level to maker ice machine keep horizontality.

Using counter board foot, ice machine level adjustment

do not use the method of adjustment level in the bottom

of foot pad hard objects. To ensure the four foot of ice

machine touches the ground steady, to prevent vibration

when machine is running.

Notice

DB Series Internet Of Things ice Machine

1.8 Power supply

Wiring used in power supply must be reliable grounding, The

wiring use must accord with the local countries and regions

laws and regulations.

Ice machine starting, allows the voltage fluctuation

range is + / - 10% of rated voltage.

The ice maker must have a separate fuse/circuit

breakers.

The maximum capacity of this series machine we

recommended fuse is 15 A.

1.9Water supply/drainage

The water supply

According to the local water supply condition, to

determinewhether to need to install the watertreatment

system, used to prevent formation sediment, and filter

out the impurities, removethe smell of bleach.

Ice machine must be connected to a drinkable water.

Don't put ice machine connected with hot water .

If the water pressure over the allowed maximum

feed waterpressure of (5 bar), pls buy a water

pressure regulator.

Ice machine must be installed water valve in front

of all theinlet pipe.

Drainage

When installing a drain, should prevent water poured into

the ice machine or the ice storage bin , please observe the

following guidelines:

Main drain should be thick enough, to be able to

dischargeall the water in the drain pipe.

Ice storage bin and water-cooling condenser pipes

should be separated, and coated heat preservation

material, in order to prevent condensation.

Every one metre long drainage pipe must have a drop

of 2.5 cm. And there can not be bended.

Please follow the following guide to install water supply

pipe:

Good

Downward sloping

warning

Effect is bad

Upward sloping

Effect is bad