ClearWater clearspa Manual de instruções de instalação - Página 7

Procurar online ou descarregar pdf Manual de instruções de instalação para Banheiras ClearWater clearspa. ClearWater clearspa 8 páginas.

13. Operating the touch pad. – The touch pad has three operating buttons.

Button B

Button A – Starts and stops the motor. As seen in the picture above, an LED indicates

when the blower is on or off, this light also indicates whether the hygiene system is

Button B – This is the variable speed button, press and hold to decrease and increase

the speed of the blower, release the button at your required pressure.

Button C – This is the massage button, once pressed the speed varies from the high

speed to slow speed continuously over a period of time. If the button is pressed again

the speed of the motor will carry on at that speed.

The blower will last approximately 30 minutes; after the 30 minutes have elapsed the

blower will turn itself off. This is a safety feature ensuring the blower does not over

heat. If the blower does not have sufficient room to breath the running time of the

Once the bath has been emptied and the Clearspa system has been turned off, the LED

on the stop start button (A) will flash to indicate the hygiene system is active. The

hygiene system is programmed into the blower. The blower will start up again in

approximately 15 minutes after it has been turned off at the touch pad. The objective

of the hygiene system is to purge the remaining water out of the system and into the

base of the bath where it can drain away. The hygiene system should last for

approximately five minutes. After the five minutes have elapsed the motor will turn

itself off. We suggest that you run the system even if the Clearspa has not been used,

this can be done by turning the system on and off again engaging the Hygiene system.

Button A

on.

Check all sealed areas for any leaks

Section 4

System operation

blower will be less.

Hygiene system

Clearwater Clearspa Instructions 09/06

Button C