ARTFOX Lighting Matrix Beam 5.5 Manual do utilizador - Página 2
Procurar online ou descarregar pdf Manual do utilizador para Equipamento de DJ ARTFOX Lighting Matrix Beam 5.5. ARTFOX Lighting Matrix Beam 5.5 9 páginas.
Imprimir página1. Safety Introductions
Please read the instructions carefully which includes important
information about the installation, operation and maintenance.
WARNING
Please keep this User Manual for future consultation. If you sell the fixture to another
user, be sure that they also receive this instruction booklet.
Unpack and check carefully there is no transportation damage before using the fixture.
It's important to ground the yellow/green conductor to earth in order to avoid electric
shock.
Disconnect main power before servicing and maintenance.
The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
Maximum ambient temperature is Ta : 40℃. Don't operate it where the temperature is
higher than this.
Unit surface temperature may reach up to 85℃. Don't touch the housing bare-hand
during its operation. Turn off the power and allow about 15 minutes for the unit to cool
down before replacing or serving.
In the event of serious operating problem, stop using the fixture immediately. Never try
to repair the fixture by yourself. Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance
center. Always use the same type spare parts.
Do not connect the device to any dimmer pack.
Do not touch any wire during operation and there might be a hazard of electric shock.
To prevent or reduce the risk of electrical shock or fire, do not expose the fixture to rain
or moisture.
The housing must be replaced if they are visibly damaged.
Do not look directly at the LED light beam while the fixture is on.
There are no user serviceable parts inside the fixture. Do not open the housing or
attempt any repairs by yourself. In the unlikely event your fixture may require service,
please contact your nearest dealer.
Due to the magnifying type lens, please keep the lens out of contact with direct sunlight.
Direct sunlight can cause heat to build up inside of the unit, which will seriously damage
unit.
2A
If using a 230Vac 50Hz power supply, do not connect in series more than
8 units, use another mains supply for the next 8 units.
If using a 120Vac 60Hz power supply, do not connect in series more than
4 units, use another mains supply for next 4 units.
2. Technical Specifications
DMX 1/4/9/25/29 channels switchable.
Smooth 0~100% dimming and variable strobe speeds.
Three operation modes: DMX, Mater/Slave mode, Sound Active.
Ideal for discotheques, clubs, bars, parties, Mobile DJs, ect.
Power Supply: 120~230V 50/60Hz
Fuse: T 6.3A
Power consumption: 250W
LED: 25 x 10W WW LED
Dimension: 600 x 600 x 85mm
Weight: 13.8 kgs
3A