ArtFox Lightning FLEX BEAM K8 RGBW Manual do utilizador - Página 7

Procurar online ou descarregar pdf Manual do utilizador para Luz de inundação ArtFox Lightning FLEX BEAM K8 RGBW. ArtFox Lightning FLEX BEAM K8 RGBW 12 páginas.

Imprimir página

Note:

There is only one Projector to be set as a Master in a signal Cable. If Master's functions used, Please

disable DMX control signal.

When multiple projectors' work together in synchronous control state, Parameters can be

transmitted from the master projector to the slave projectors such as DMX channel mode, Display

setting status and operation mode (User memory data is included). Before parameters transmitted,

the projector which will send parameters should be set as a Master and others be as Slaves.

4. How to Control the Unit

You can operate the unit in three ways:

1. By master/slave built-in preprogram function

2. By DMX controller

No need to turn the unit off when you change the DMX address, as new DMX address setting will

be affected at once. Each time you turn the unit on, it will show "BEAM-K8" on the display. After

that the unit will be ready to receive DMX signal or run the built in programs.

4.1 Master/Slave Built In Preprogrammed Function

By linking the units together in master/slave, the first unit (the master) will control the other units

(the slave) to give an automatic, sound activated, synchronized light show. This function is good

when you want an instant show.

To set the first unit as a master, press the ENTER button to show the MASTER MODE on the display.

To set the unit as a slave, press the ENTER button to show SLAVE MODE on the display.

4.2 DMX Address Setting

To set the DMX address, press the MENU button to show DMX Address on the display. Press the

ENTER button. Use the DOWN and UP button to change the DMX address. Once the address has

been selected, press the ENTER button to setup, to go back to the functions without any change

Defaults

System Reset

YES, NO