AKKU SYS 9885599 Manual do utilizador - Página 6

Procurar online ou descarregar pdf Manual do utilizador para Painel solar AKKU SYS 9885599. AKKU SYS 9885599 8 páginas. Mobile solar module

User Manual

a-TroniX PPS solar bag vario

4. Setup and operation

Place the a-TroniX PPS solar bag vario on a flat surface with direct sunlight. Make sure

that no branches or other obstacles cast shadows on the solar module.

In order to obtain the greatest possible output, the solar module should be aligned as

perpendicularly as possible to the sun.

NOTE:

Make sure that the connected cables do not pose a risk of accident and that

■

they cannot be damaged by being accidentally stepped on or run over. Avoid

water getting into the connection sockets.

Using a suitable charge controller (not included), this solar module can be

■

used to charge all common batteries.

Connect the battery to be charged to the correct outputs of the charge con-

■

troller. Refer to the corresponding operating instructions of the solar charge

controller.

When wiring the connections, ensure that the polarity is correct to avoid short

■

circuits.

USB-connections

The a-TroniX PPS solar bag vario has two integrated USB connections (5 V, 2 A).

It offers the possibility of fast charging and power supply of mobile devices.

LED lights up green (module is charging)

Open circuit

>14V

NOTE:

If the LED light flashes, switch off the solar module and the load to check if there

is a short circuit.

If the LED light is red, remove the connected load or place the solar module on a

surface with direct sunlight.

Page 6

LED display status

Load

>14V/<14V,>0.5mA

LED lights up red (module not charging)

Open circuit

<14V

Load

<14V/<14V,<0.5mA

10/2021