Artico SY-PA500 Manual do utilizador - Página 15

Procurar online ou descarregar pdf Manual do utilizador para Filtro de ar Artico SY-PA500. Artico SY-PA500 16 páginas.

Imprimir página

Problem

The appliance

doesn't work

The airflow has

significantly

reduced

The fan speed does

not change to

automatic mode.

Poor performance

Too noisy

Possible cause

The filter cover is not closed properly Remove the filter cover and

Power plug is not connected to a

power supply.

The appliance is not turned on.

Filters packaging has not been

removed.

The air quality is good and

therefore the automatic mode

has been activated.

Sleep mode has started automatically,

the LED indicator turns off, while the

fan speed and noise level are also

reduced.

The Pre-filter is too dirty.

The filter has not been replaced.

Insufficient space and ventilation in

the surroundings.

The air quality sensor is humid, or

the ambient temperature is too high,

causing condensation on the

sensor.

The room area is too large.

The air inlet or outlet of the appliance

are blocked.

Filter's plastic packaging haven 't been

removed.

The air quality sensor is dirty.

reinstall it.

Unplug and reconnect power.

Plug in the power and turn the air

purifier back on.

Filter's plastic packaging

should be removed before

use.

In automatic mode, the

appliance will automatically

adjust the fan speed to save

maximum energy.

Press the fan speed button and

choose the desired fan speed.

Please clean up the Pre-filter.

Replace with a new filter.

Make sure there is at least 15

inches (38 cm) of free space in all

directions around the purifier.

Make sure the air quality sensor

is clean and dry.

Use the air purifier in a smaller

room.

Clean the air inlet and outlet and

remove any obstructions.

The plastic packaging of the

filter must be removed before

use.

Clean the air quality sensor.

Possible solution