Artila M-508 Manual de instalação rápida - Página 2

Procurar online ou descarregar pdf Manual de instalação rápida para Placa-mãe Artila M-508. Artila M-508 7 páginas.

Imprimir página

Power LED (PWR)

Power LED will keep solid green when power is applied.

Ready LED (RDY)

After Power ON, M-508 will decompress the kernel and root file

system to RAMDISK. Once system is boot up, the Ready LED will

show solid green. The Ready LED will be turned off after M-508

received "halt" command.

Link/Act (LAN)

When Ethernet port are connected to the network, Link/Act will show

solid green and if there is traffic in the Ethernet, this LED will flash

Serial Port LED (LD3~LD6)

These four dual color LEDs indicate the data traffic at the serial ports.

When RXD line is high then Orange light is ON and when TXD line

is high, Green light is ON.

Debug LED (LD1~2)

The debug LEDs are located near LAN LED and are used for system

boot debug. If system are correctly boot, they are switch off.

Serial Port

The serial port pin assignment is shown as follow:

Port 1/3: RS-232/422 (software selection)

RS-232: RXD,TXD,RTS,CTS,GND

RS-422: TXD+, TXD-,RXD+,RXD-,GND

Port 2: RS-232/422 (software selection)

RS-232: RXD,TXD,RTS,CTS,DSR,DTR,DCD,GND

RS-422: TXD+, TXD-,RXD+,RXD-,GND

Port 4: RS-232/422/485 (software selection)

RS-232: RXD,TXD,RTS,CTS,GND

RS-422: TXD+, TXD-,RXD+,RXD-,GND

RS-485: Data+, Data-, GND

Serial Console Port:

Serial console port is used for accessing M-508 using RS-232. At

factory, serial console port is disabled because serial console port

shares the Port 3 connector with the pin definition as shown:

User need to prepare or order a serial console cable

(CB-F9F9-100) and enable the serial console port as described in

Enable Serial Console port section.

Power Connector

Connect the +5VDC power line to M-508. If the power is

properly supply, the power LED will show a solid green color.

Please check the power voltage

and polarity before connecting it

Ethernet Port

The Ethernet Port uses RJ45 connector

SD Socket

The SD socket is compatible with SD memory card

specification version 1.0. The SD Socket is located in the back

panel of the PCB.

USB Port

The USB port is a USB2.0 high speed host port. It can be used

to expand the hardware function of M-508 and exchange file

and data between PC. Currently the hardware support by M-

508 USB is shown as follow:

USB Storage Device

USB to Wireless LAN Adaptor (Ralink RT2571)

USB to Modem (CDC compliant)

USB Camera

Contact Artila if you find your hardware is not shown on the

list.

Reset Button

Press the "Reset" button to activate the hardware reset. Please

always use "reboot" command to reset M-508. You should

only use this function if the software reboot does not function

properly.