CLEMAP Energy Monitor Manual de instruções de instalação - Página 7

Procurar online ou descarregar pdf Manual de instruções de instalação para Inversor CLEMAP Energy Monitor. CLEMAP Energy Monitor 10 páginas.

CLEMAP Energy Monitor | Installation manual

Step 2: CLEMAP connection to a WIFI network or via Ethernet cable

a. Connect to the WiFi network created by the CLEMAP product with your smartphone or laptop.

((Name: clemapXX, where XX = the last two digits of the serial number, Password:

sensorsetup). WARNING: If an Ethernet cable is connected to the CLEMAP sensor, the

clemapXX's WIFI hotspot is automatically deactivated.

NOTE: For security reasons, the hotspot is deactivated after 10 minutes without connection.

To reactivate it, press the RESET button for more than 1 second (until the status LED starts

flashing rapidly).

go to

http://192.168.1.100:4000,

cable, the IP may be different.

Figure 8

Figure 9

Figure 10

via a browser, if the sensor is connected with an Ethernet

c. Registration with

• User: clemap

• Password: The serial number on the housing

(e.g. SE12345678)

d. briefly check if the displayed consumption

values (P, V and I) for the three phases L1, L2

and L3 are realistic. In case of anomalies,

check if each current sensor matches the

correct voltage phase, if the current sensors

are connected to the correct input (main)

cable and if they "clicked" when closed

e. In the case of a WiFi connection, proceed to

the next step. In the case of an Ethernet

connection, connect the cable and go directly

to step 3.

f. Select "Network", select "Refresh" and your

Wi-Fi network from the pop-up menu and

enter your Wi-Fi password.

CAUTION: the CLEMAP product only supports

WIFI on the 2.4 GHz band. Once you have

saved the WIFI password, you can log out.

Within a few minutes, the sensor will be

connected to the WIFI network you have

chosen.