Clemas & Co KV10/1H Manual do operador - Página 5

Procurar online ou descarregar pdf Manual do operador para Aspirador de pó Clemas & Co KV10/1H. Clemas & Co KV10/1H 8 páginas. Hazardous vacuum cleaner

Imprimir página
Clemas & Co KV10/1H Manual do operador
4. Cleaning Tools and Suggested Uses
a)
Combination Carpet/Hard Floor Nozzle:- This nozzle is normally used only in conjunction
with the two stainless steel wands for the cleaning of carpets and hard fl oor surfaces. With the
bristles in the down position hard fl oors (wood, vinyl, concrete, etc) and the short pile carpets
(Flotex, corded, and carpet tiles) can be cleaned. With the bristles in the up position longer pile
carpets (foam backed and carpets with underlay) can be cleaned.
b)
Crevice Nozzle:- Used to concentrate the suction power and reach into awkward places.
c)
Dusting Brush:- Used for dusting skirting boards, ledges, cills, walls, etc.
d)
Upholstery/Stair Nozzle:- Used for stair cleaning, car cleaning, upholstery and curtains etc.
e)
Double Taper Tube:- To connect any of the accessories directly to the hose without using the
stainless steel bent hose end. Useful in confi ned areas.

FILTRATION SYSTEM

This is a Type H Vacuum Cleaner. It is fi tted with 3 stages of fi ltration on the negative pressure side
of the motor (that is before the motor, so that the motor always receives clean fi ltered air).
1st Stage – Disposable Microfi bre Bag (with sealing cap).
2nd Stage – High Effi ciency (HE) Filter Assembly specially for Type H cartridges.
3rd Stage – Type H HEPA (High Effi ciency Particulate Air) Cartridge Filter. Also known as
the Absolute or Essential Filter.
Access to the Microfi bre Bag and Filtration System
a)
To remove the motor head and HEPA cartridge unit, unclip the LOWER set of toggle clips.
Ensure that the toggle clips are hinged clear of the rim of the HEPA unit. Lift the motor head
and HEPA unit clear of the bottom can.
b)
To refi t the motor head and HEPA unit, align the head so that the switch and cable entry lie
directly opposite the hose entry on the bottom can. Locate the toggle clips over the rim of the
HEPA unit and fi rmly press down both toggle clips until they have locked into position.
Note: The upper set of toggle clips between the HEPA unit and motor head have a
lock-down screw to prevent the separation of the motor head from the HEPA unit.
Only authorised and trained personnel should separate the motor head from the HEPA unit.
WARNING
The appliance may contain dust hazardous to health. Emptying and maintenance operations including
removal and renewal of dust collection bag shall only be carried out by authorised personnel wearing
suitable approved personal protection.
WARNING
Do not use the appliance unless the full fi ltration system is fi tted – Type H cartridge, high effi ciency
cloth fi lter and Microfi bre bag. Failure to fi t the complete system may cause premature clogging of
the Type H cartridge and may also endanger health.
WARNING
Do not use this appliance for the collection of explosive dusts (a list of which can be obtained from
your local fi re prevention offi cer).
Do not use this appliance in a corrosive or fl ammable environment.
IMPORTANT
The vacuum unit is designed to collect hazardous dusts: Therefore any dust found within the machine
or on its fi lters may be dangerous to your health. Always take precautions.