Custom Crimp CC150 Manual do operador - Página 8

Procurar online ou descarregar pdf Manual do operador para Ferramenta de cravar Custom Crimp CC150. Custom Crimp CC150 17 páginas. General production hose crimper

Imprimir página

CRIMPING/CALIBRATION

CC150

General Production Hose Crimper

CRIMPING

Select the correct die for the combination of hose and fitting being

crimped. Consult the hose and fitting manufacturer's specifications

for the correct die to use and the final crimp diameter required.

The final crimp diameter will be the closed diameter stamped on the

face of the die plus the number shown on the micrometer gage. See

the micrometer setting example below:

Micrometer Setting Example

Each 100 on the micrometer dial represents 1 mm above the

closed diameter of the die set. For example, with a 57mm

die set installed and the micrometer set at 240 as shown in

the photo, the final crimp diameter would be 59.4 mm ( 57mm

+ 2.4mm)

Insert the hose and fitting in the crimper head to the correct depth

and press and hold the foot switch until the crimper shuts off. If the

AccuStop

coupling stop is being used make settings according to

instructions.

Check the finished crimp diameter with calipers to be certain that it is

within the hose manufacturer's specifications.

CRIMPING