artisan 5400-ES Manual do utilizador - Página 15
Procurar online ou descarregar pdf Manual do utilizador para Controlador artisan 5400-ES. artisan 5400-ES 18 páginas. Event controller
5400-E Power Wiring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INPUT POWER MATING
CONNECTOR WITH WIRES
115
VAC
5400-E Typical Wiring – Direct To Bells or To Alarm System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The 5400-E outputs OUT1 and OUT2 are normally open relay contacts, there is no power connected to them. They can switch
any AC or DC power source directly to the bells, or they can be wired to the 'TEST' or 'ACTIVATE' inputs on most alarm
systems.
AC or DC
Bell
Power
Source
V1.08
Notice: Artisan Controls Corporation assumes no responsibility for customers applications or product design. The information and data contained herein is the sole and
exclusive property of Artisan Controls Corporation. Any duplication, misuse, or conversion of this information without the express written consent of Artisan Controls
Corporation is illegal and will result in damages including court costs and attorney fees being assessed against the party misusing this property
5400-E & -ES Event Controller User's Manual
Artisan Controls Corporation, 111 Canfield Ave., Bldg B15-18, Randolph, NJ 07869
Page 15
www.artisancontrols.com
To connect your wiring to the 5400-E connectors,
first strip the wire to about ¼", then press a small
screwdriver into the slot as shown to open the
connector, then finally insert the wire and remove
the screwdriver
Alarm
System
Controller
Table of Contents