3Jtech wifiCAMit Manual do utilizador - Página 6
Procurar online ou descarregar pdf Manual do utilizador para Câmara IP 3Jtech wifiCAMit. 3Jtech wifiCAMit 15 páginas.
Imprimir páginahttp://www.3jtech.com.tw
http://www.pnpipcameras.com
wifiCAMit User's Guide
2.2 Illustration
No. in
Name on
Figures
wifiCAMit
RJ45 network
1
connector
RJ22 power
2
supply connector
3
Lens
4
Antenna
5
Wire/Wireless
switch
6
RFIO slot
7
SW_1
8
SW_2
Camera
9
information
LED
10
2.2.1 Front Panel Information
RJ45 Network Connector
wifiCAMit is designed for 10/100Mbps Ethernet networks. wifiCAMit connects to the network via
category 5 cable.
Copyright of 3JTech Co., Ltd. (also doing business as A3J Engineering Inc.)
Description
To connect to the camera and
Ethernet port via RJ45 cable
To connect to the camera and
power adapter via RJ22
interface
300k pixels CMOS sensor
For wireless access
To change the wired or
wireless mode for wifiCAMit
To install the optional RFIO
device
Press SW_1 button, then
wifiCAMit will perform the
power reset
Press and hold SW_2 button
for 5~10 seconds to reset the
camera to its factory defaults
Serial number, camera ID and
firmware version
To display the status of the
camera in wired or wireless
mode
6
Remark
Refer to section 2.2.1 for front
panel information
Refer to section 2.2.1 for front
panel information
Refer to section 2.2.1 for front
panel information
Refer to section 2.2.1 for front
panel information
Refer to section 2.2.1 for front
panel information
Refer to section 2.2.1 for front
panel information
N/A
The green indicator LED of RJ45
port will light when it is finished
with the reset procedure
Refer to section 2.2.2 for real
panel information
Refer to section 2.2.3 for LED
description on the rear panel