Artison MEZZ-8-SURR Manual de instalação - Página 5

Procurar online ou descarregar pdf Manual de instalação para Altifalantes Artison MEZZ-8-SURR. Artison MEZZ-8-SURR 8 páginas. Mezzanine 8 surround

C. When possible keep the speakers at least two feet away from any corner or meeting

of the wall and ceiling.

D. NOTE: These are only recommendations; your specific room application will

determine the final height and placement of the surround speaker mounting.

2. Speaker Installation

A. Once the rough speaker locations have been identified, use the supplied cutout

template, and mark the cutout lines in pencil.

check the speaker location for any obstruction in the wall/ceiling that may not be

visible, this should be done with a 'stud-finder' device.

B. Trim off approximately 3/8" [9 mm] of speaker wire insulation to expose bare

conductors. Connect the speaker wires to the corresponding positive (Red) and

negative (Black) speaker terminals.

C. Using a #2 Philips Screwdriver tighten the dog-leg clamps. Tighten screws in a star

pattern, alternating sides. Be careful not to over tighten as this may damage the

wall surface or speaker.

3. Painting Grilles

A. When painting the A.I.R. Grilles, remove the grille and trim ring assembly from the

speaker and paint separately.

B. The fabric scrim coating should be gently removed from the grille and set aside before

painting and replaced after drying is complete.

baffle or drive units. Paint can damage the components which would VOID

your Warranty.

C. Paint with a spray application. Using compressed air will help to avoid excess paint

from collecting and blocking the mesh. The grille is powdercoated steel and the trim

is PVC.

Before cutting into the wall/ceiling,

DO NOT get paint on the speaker