DK-TEC HNEFGC Manual do utilizador - Página 10

Procurar online ou descarregar pdf Manual do utilizador para Equipamento agrícola DK-TEC HNEFGC. DK-TEC HNEFGC 16 páginas. Flail mower

6. Clear the area to be cut of stones, branches and other foreign objects.

7. Lower the flail mower to the ground. Set the throttle on the tractor to approximately. 1/4

open. Connect the PTO so that the blades start rotating.

8. Operate with 540 rpm PTO.

9. The first time the flail mower is used, first drive forward at a slow speed and then increase

speed until the desired speed is reached – but observe the max 540 PTO rpm.

the

10. The hammer knifes will cut better with fast blade speed.

11. After mowing the first 15 meters, the work is stopped and it is checked that the flail mower

is adjusted correctly.

Starting the Machine

Before starting the flail mower, the following are

•

Tension of the

straps

•

Oil level

of the gearbox

•

Lubricating on bearings and PTO.

•

All bolts, nuts and screws are tightened sufficiently.

Follow all the safety precautions described in this manual. The machine is mounted with a standard

category 1 three-point suspension.

Reverse the tractor to the machine and lower the lift arms. Turn off the tractor. Adapt the machine

by hand to connect the two lift arms. Itmust be ensured that both are secured with a split. Connect

the top bar and adjust the slinger chains to allow minimal sideways movement. Connect the PTO

and tractor. It must be ensured that the PTO has been cut off so that it is the right length.

(if necessary, refill with a gear oil 80/90)

checked:

09/2019